Motor Type 1 Tritran Remote For Garageway Models User Guide

Motor Type 1 Tritran Remote For Garageway Models

“

Product Information

Specifications:

• Motor Type 1 (DOOR CODE)
• Motor Type 2 (CODE SET)

Product Usage Instructions

Programming Remote Directly to Motor:

1. Press and hold buttons 1 and 2 (top 2 buttons) on the new
   remote simultaneously. The green indicator light on the remote will
   turn on. Continue holding both buttons until the light turns off
   (in about 5 seconds).
2. You have now successfully adjusted the frequency to match your
   motor’s frequency.
3. Find the Code Set button on your motor. If your motor has a
   clear plastic cover over the buttons, remove it to access
   them.
4. Briefly press and release the Code Set button (labelled ‘DOOR
   CODE’) on the motor. A red LED on the motor will light up.
5. Press the desired button on the new remote that you want to
   pair with the motor. Hold it for 1-2 seconds. The red light on the
   motor will begin flashing.
6. Press that same button on the remote again. The flashing light
   on the motor will stop. Your remote is now successfully programmed
   and ready to operate the gate.

Frequently Asked Questions (FAQ)

Q: How do I know if the remote programming was successful?

A: Once you complete the programming steps, the red light on the
motor should stop flashing, indicating that the remote is
successfully programmed.

Q: Can I program multiple remotes to operate the same
gate?

A: Yes, you can repeat the programming steps for each additional
remote you want to pair with the motor.

“`

Programming Remote Directly to Motor
1. Press and hold buttons 1 and 2 (top 2 buttons) on the new remote simultaneously. The green indicator light on the remote will turn on. Continue holding both buttons until the light turns off (in about 5 seconds). remote will turn on. Continue holding both buttons until the light turns off (in about 5 seconds).
2. You have now successfully adjusted the frequency to match your motor’s frequency.
3. Find the Code Set button on your motor. If your motor has a clear plastic cover over the buttons, remove it to access them.
4. Briefly press and release the Code Set button (labelled ‘DOOR CODE’) on the motor. A red LED on the motor will light up.
5. Press the desired button on the new remote that you want to pair with the motor. Hold it for 1-2 seconds. The red light on the motor will begin flashing.
6. Press that same button on the remote again. The flashing light on the motor will stop. Your remote is now successfully programmed and ready to operate the gate.

Motor Type 1 (DOOR CODE)

Motor Type 2 (CODE SET)

Documents / Resources

Garageway Motor Type 1 Tritran Remote For Garageway Models [pdf] User Guide Motor Type 1, Motor Type 2, Motor Type 1 Tritran Remote For Garageway Models, Motor Type 1, Tritran Remote For Garageway Models, Garageway Models, Models

References

• User Manual