GALAX REV05 PC Case
Explosive view
- Dust filter
- Top panel
- M/B
- Right side panel
- Front plate
- Bottom plate
- PSU cover
- Left tempered glass side panel
- Rear panel
- Dust filter on the bottom
PSU installation
M/B installation
HDD installation
- Loosen 2pcs screws for HDD bracket, pull out HDD bracket
- Fix HDD on bracket
SSD installation
- Firstly place SSD on top of bracket as shown above and lock screws; then insert HDD inside.
- Put bracket on chassis after HDD installation, and lock 2pcs screws
- Take off SSD bracket, then fix SSD on bracket and lock bracket to previous place
Fan and Water cooling installation
Install fan and water cooling on top panel
Put fan or water cooling on top panel from inner side and fix screws from Outside
Install fan and water cooling on front plate
Put fan or water cooling on front plate from inner side and fix screws from outside
Install fan and water cooling on rear panel
Put fan or water cooling on rear plate from inner side and fix screws from outside
Install fan on PSU cover
- Put fan on upside of PSU cover and fix screws
- Place VGA card on M/B and adjust the height accordingly, then insert the 2pcs screws to fix in place.
Install side panel
- Put side panel on right position and push it, then lock 2pcs screws
- Open left side panel and remove the tempered glass side panel
Documents / Resources
 |
GALAX REV05 PC Case [pdf] Installation Guide REV05 PC Case, REV05, PC Case, Case |
