PATH LIGHTS
MP-K, MP-Z, MP-J,
MP-30/31, MP-40
RP-34/35 FX-259 2.
MP-K Designer Path Lights
LANDSCAPE & ARCHITECTURAL LIGHTING | Learn more. Visit fxl.com
 |
 |
 |
 |
| RP LED board replacement fxl.help/rpledboard |
LED board replacement fxl.help/mplboard |
Voltage Drop Calculator fxl.com/voltage-drop-calculator |
Path Light Spacing Calculator fxl.com/pl-space-calc |
Please read and keep all safety and use instructions. If you have questions, contact your local distributor or visit the online support section at fxl.com/support.
WARNING – To reduce the risk of FIRE OR INJURY TO PERSON:
- Turn off/unplug and allow to cool before replacing lamp.
- Lamp gets HOT quickly. Contact only switch/plug when turning on.
- Do not touch hot lens, guard, or enclosure.
- Keep lamp away from materials that may burn.
- Do not touch the lamp at any time. Use a soft cloth. Oil from skin may damage lamp.
- Do not operate the fixture fitting with a missing or damaged shield.
WARNING – Risk of Electric Shock
- May be installed less than 5′ (1.5 m) from a pool, spa, or fountain when used with a UL 379 listed transformer.
- A fixture shall not use tungsten halogen lamps unless the fixture is marked for such lamps.
- Supply connection and electrical components are located above ground level, except for secondary cord that is suitable for wet locations.
LOW-VOLTAGE CABLE SHALL:
- Be protected by routing in close proximity to the fixture or fitting or next to a building structure, such as a house or deck.
- Not be buried except for a maximum 6″ (152 mm) in order to connect to the main low-voltage cable.
- Have the length cut off so that it is connected to a connector within 6″ (152 mm) from a building structure, a fixture, or fitting.
fxl.com/support
These products contain a light source of energy efficiency class G.
Documents / Resources
 |
FXLuminaire MP-K Designer Path Lights [pdf] Instruction Manual MP-K, MP-K Designer Path Lights, Designer Path Lights, Path Lights, Lights |