SPECIALTY LIGHT | SRP
Instruction Manual
INCLUDED COMPONENTS
COMPONENTES INCLUIDOS
TOOLS & MATERIALS REQUIRED (SOLD SEPARATELY)
HERRAMIENTAS Y MATERIALES
CIRCUITING GUIDELINES
 |
 |
| fxl.help/circuiting | fxl.help/SRP |
INSTALLATION
| 1. Measure and cut the length requiredfor installation. | 2. Insert the U-Spacer into the end of the strip light. |
 |
 |
| 3. Insert a Jumper Wire into the strip light. Ensure jumper pins are installed on top of the copper pads. Use the Pick Tool to expose the pads prior to installing the jumper. | 4. Install the clear plastic Clamp onto the jumper connection. Press down firmly. Gently pull the connection to confirm it is secure. |
 |
 |
| 5. Insert the End Connector on the opposite end. Install the Clamp. Press down firmly. Pull the connection are ato confirm it is secure. |
6. Starting at one end, insert the strip slight into the aluminum SRP-CHN Channel Mount. (If using the SRP-MNT Hardscape Mount, skip this step and move directly to Step 7.) |
 |
 |
| 7. Press the strip light into the installed SRP-MNT Hardscape Mount. The ideal placement is one mount every 20″ (508 mm) or less. |
 |
TRANSFORMERS
Single transformer: When using one transformer, center the transformer on the wattage load. Minimize all cable runs to reduce voltage drop.
Multiple transformers: When using multiple transformers, spread the load evenly across all transformers. Avoid voltage drop by installing the transformers as close to the fixtures as possible.
WARNING – To reduce the risk of FIRE OR INJURY TO PERSON:
- Turn off/unplug and allow to cool before replacing lamp.
- Lamp gets HOT quickly. Contact only switch/plug when turning on.
- Do not touch hot lens, guard, or enclosure.
- Keep lamp away from materials that may burn.
- Do not touch the lamp at any time. Use a soft cloth.
Oil from skin may damage lamp. - Do not operate the luminaire fitting with a missing or damaged shield.
WARNING – Risk of Electric Shock
- May be installed less than 5′ (1.5 m) from a pool, spa, or fountain when used with a UL 379 listed transformer.
- A luminaire shall not use tungsten halogen lamps unless the luminaire is marked for such lamps.
- Supply connection and electrical components are located above ground level, except for secondary cord that is suitable for wet locations.
LOW VOLTAGE CABLE SHALL:
- Be protected by routing in close proximity to the luminaire or fitting, or next to a building structure such as a house or deck.
- Not be buried except for a maximum 6″ (152 mm) in order to connect to the main low voltage cable.
- Have the length cut off so that it is connected to a connector within 6″ (152 mm) from a building structure, a luminaire, or fitting.
This product contains a light source of energy efficiency class G.
LANDSCAPE & ARCHITECTURAL LIGHTING
Learn more. Visit fxl.com
Documents / Resources
 |
FX Luminaire SRP RGBW Strip Light [pdf] Instruction Manual SRP RGBW Strip Light, SRP, RGBW Strip Light, Strip Light, Light |
