FUTURE 2BM44 Wireless Display Adapter User Manual
Product Overview
Definition of Lights:
- Normal operation: green light on
- Charging: green light flashing
- Fully charged: the green light will stay on
- 50% battery: yellow light on, below 10%: red light on
- If no connection to Wi-Fi is made within 5 minutes while powered on, the MCU will power off.
Wireless Display Adapter is connected to the Future Crosser through the type-c data cable and turned on.
Android Phone Connection Method
Open the phone settings – go to “More Connections” – select “Screen Casting” – turn on “Wireless Casting” – connect to Anycas-xxxx
iPhone Connection Method
- Screen Casting Method for Outdoor Situations without Wi-Fi:
Step 1 (Network Setup): Open the phone settings – go to “WLAN” – connect to Anycas-xxxx
Step 2:Open the phone’s screen mirroring – connect to Anycas-xXXX - Screen Casting Method for Home Wi-Fi Situations:
Step 1 (Network Setup): Open the phone settings – go to “WLAN” – connect to Anycas-xxxx
Step 2:Open the browser – enter the URL: 192.168.68.1 or scan the code select your home or company Wi-Fi network -Click “OK”-
Step 3:Open the phone’s screen mirroring – connect to Anycas-xXXX
Instructions for Using the Function Keys
Press and hold the function key to clear the WiFi connection records of the Wireless Display Adapter.
This function is used to clear the WiFi that the device was previously connected to, ensuring successful screen mirroring when the device is under the same WiFi.
FCC Warning
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
Any Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates uses and can radiate
radio frequency energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
The device has been evaluated to meet general RF exposure requirement. The device can be used in
portable exposure condition without restriction.
Documents / Resources
 |
FUTURE 2BM44 Wireless Display Adapter [pdf] User Manual 2BM44-FUTURE, 2BM44FUTURE, 2BM44 Wireless Display Adapter, 2BM44, Wireless Display Adapter, Display Adapter, Adapter |
