FURN FT1210ZW Remote Control Transmitter

Specifications

• Model: FT1210ZW
• Type: Remote Control Transmitter
• LED Indicator: Yes
• Battery Type: Standard AAA
• Frequency: 2.4 GHz

Product Usage Instructions

Operation Instructions

1. Press the key on the transmitter to activate the device.

1. LED Indicator
2. Fan ON/OFF (Pairing button)
3. Fan Forward/Reverse
4. Light ON
5. Light OFF
6. Fan Speed(The lowest gear is 1st gear and the highest gear is 5th gear)
7. BATTERY 12V/23A x 1

Use precautions

1. When pressing the key of the transmitter, the LED indicator doesn’t light up, please inspect the battery installation.
2. When pressing the key of the transmitter, the LED indicator flashes, which means the battery get low voltage, please replace a new one.
3. Please pull out of the battery from the transmitter when leaving it unused for a long time.

FCC Instructions

This product has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This product generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If the product does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the product and receiver.
• Connect the product into an outlet on a circuit different from that to which the receiver is connected. — Consult the dealer or an experienced radio/TV technician for help.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

1. this device does not cause harmful interference, and
2. this device must accept any interference received, including interference that may cause Undesired operation.

Warning: Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the product.

IC Caution:

• RSS-Gen Issue 5 “&” RSS-Gen numéro 5 – English:
• This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada’s licence-exempt RSS(s). Operation is subject to the following two conditions:
  1. This device may not cause interference.
  2. This device must accept any interference, including interference that may cause undesired operation of the device.
• Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

RF exposure statement:
The equipment complies with the IC Radiation exposure limit set forth for an uncontrolled environment.

FAQs

Q: What should I do if the LED indicator does not turn on?
A: Check the battery installation and ensure it is correctly inserted.

Q: How do I know when to replace the battery?
A: If the LED indicator flashes when pressing a key, it indicates low battery voltage and requires a new battery.

Q: Should I remove the battery if I won’t be using the transmitter for a long time?
A: Yes, it is recommended to remove the battery if the transmitter will be unused for an extended period to prevent any potential battery leakage.

Documents / Resources

FURN FT1210ZW Remote Control Transmitter [pdf] User Manual FT1210ZW, FT1210ZW Remote Control Transmitter, Remote Control Transmitter, Control Transmitter, Transmitter

References

• User Manual