FUNSNAP CAPTURE 2s Gimbal 2200 mAh 3 Axis Stabilisation
IMPORTANT INSTRUCTIONS
0 Do not drop or hit against your Capture 2s vigorously, which may cause damage to it.
O Please do not spill any liquid onto your Capture 2s. It is recommended to use a soft dry cloth to clean it.
O Please avoid any sand or dust to get into your Capture 2s during the use.
O When you power on Capture 2s , please hold the handle vertically and stably. Do not shake it during the startup process; otherwise, it may cause an abnormal startup.
OBefore using your Capture 2s, please ensure that the powerls sufficlent.
OWe recommend to recharge and discharge Capture 2s every 3 months or so to maintain a healthy battery state.
OPlease do not charge your Capture 2s near flammables. Always keep an eye on the charging process to avoid any risk.
ODon’ t keep the device out of battery for a long time, which may cause damage to the battery cell. If you will not use it for a long time, please charge it to 45%-65% power (indicated by 2-3 bars in Capture2 App ), then store it.
0Do not use or store Capture 2s near a fire source or in an environment with a high temperature of 600C(1400F) or above.
@ Only use the original charging cable provided by FUNSNAP to charge your Capture 2s.
Capture 2s has a built-in lithium battery, please do not disassemble it by yourself.
11 Do not dispose of your Capture 2s in your household waste due to the battery inside. Dispose of
12 it following your local environmental laws and regulations.
PRODUCT OVERVIEW
Buckle
Adjustable Arm
Pan Axis
Battery Level Indicator
Handwheel
Power/Mode Button
Rotatable Phone Holder
Tilt Axis
Tilt Motor
Pan Motor
Mode Indicator
Joystick
Photo/Video Button
1/4″ Tripod Mounting Thread
Roll Motor
Type-C Port
Trigger
Mounting Slot
Roll Axis
CHARGE YOUR CAPTURE 2S
Please fully charge your Capture 2s before your first use. To charge it, connect a USB adapter (not included) to the Type-C port with the USB Cable provided.
Charging:
The Battery Level Indicator flashes red.
Fully Charged:
The Battery Level Indicator turns solid green.
-O- Tip:
We recommend charging the Capture 2s in the power-off state.
MOUNT AND BALANCE A MOBILE PHONE
O IMPORTANT:
@ Only mount and balance a mobile phone when your Capture 2s is powered off.
@ It’s not recommended to mount the mobile phone with a case.
Mount and Balance A Mobile Phone Horizontally
Step 1:
Take out your Capture 2s from the Carrying Bag.
Step 2:
Pull both sides of the Phone Holder outwards, place your phone into the holder, then release.
Step 3:
Unfold the Roll Axis rightwards to unlock the Buckle.
USE YOUR CAPTURE 2S
Controls and Operations
1. Power/Mode Button
Power On/Off
Press and hold the Power/Mode Button for 3 seconds to power the Capture 2s on/off.
Gimbal Modes
After powering on, short press the Power/Mode Button to switch the gimbal modes between Pan & Tilt Follow Mode and FPV Mode.
Documents / Resources
 |
FUNSNAP CAPTURE 2s Gimbal 2200 mAh 3 Axis Stabilisation [pdf] User Manual CAPTURE 2s Gimbal 2200 mAh 3 Axis Stabilisation, CAPTURE 2s, Gimbal 2200 mAh 3 Axis Stabilisation, Axis Stabilisation, Stabilisation |