FUNPOWER FT12W10YGB Remote Control Transmitter
Operation Instructions
- LED Indicator
- Fan OFF
- Fan Speed 1~6
- Fan Forward/Reverse
- Light Control
- Power switch
Use precautions
- When press the key of the transmitter, the LED indicator doesn’t on, please check whether the power switch is on.
- Please disconnect the power switch when left unused for a long time.
FCC
FCC Instructions:
This product has been tested and found to comply with the limits for a Class B digital device, under Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This product generates, uses, and can radiate radio frequency energy and, if not installed and used by the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If the product does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures.
- Reorient or relocate the receiving antenna.
- Increase the separation between the product and the receiver.
- Connect the product to an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
- this device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation.
Warning: Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the product.
- The device has been evaluated to meet general RF exposure requirements.
- The device can be used in portable exposure conditions without restriction.
FCC ID: 2ABUP-FT12W10YG
IC Caution:
RSS-Gen Issue 5 “&” RSS-Gen numéro 5: This device contains license-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada’s license-exempt RSS(s).
Operation is subject to the following two conditions:
- This device may not cause interference.
- This device must accept any interference, including interference that may cause undesired operation of the device.
Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
RF exposure statement:
The equipment complies with the IC Radiation exposure limit set forth for uncontrolled environments. The device has been evaluated to meet general RF exposure requirements. The device can be used in portable exposure conditions without restriction.
Documents / Resources
![]() |
FUNPOWER FT12W10YGB Remote Control Transmitter [pdf] User Manual FT12W10YG, FT12W10YGA, FT12W10YGB Remote Control Transmitter, FT12W10YGB, Remote Control Transmitter, Control Transmitter, Transmitter |