
FUNKY Monkey bars Swing Set

Specifications
- Recommended for assembly by 2 adults
- Assembly time: 1-2 hours
- Tools required for installation:
- 1x 8mm Allen key (Included)
- 1x Soft Hammer (Not included)
- 1x 17mm Ratchet (Not included)
- 1x Spirit Level (Not included)
- 1x Tape Measure (Not included)
- 2x 3m Step Ladder (Not included)
- Fittings and Tubes included as specified
WARNING
PLEASE CAREFULLY READ ALL INFORMATION CONTAINED IN THIS ASSEMBLY MANUAL BEFORE YOU INSTALL AND USE YOUR FUNKY MONKEY BARS®.
SAFETY NOTICE
- Any person handling or using the Funky Monkey Bars® products must follow the instructions as described in this document. The person in charge of assembling and using the equipment must ensure that the recommendations for use given in this document are seen by all users.
- Only use the Funky Monkey Bars® after they have been fully assembled and after checking that the fittings are tightened properly (refer to page 3 – Correct Tightening Method).
- DO NOT install your Funky Monkey Bars® over concrete, asphalt, packed earth, wood decking or any other hard surface. A fall onto a hard surface can result in serious injury or death.
- Inspect all grub screws, bolts and nuts at the beginning of each play session to ensure your Funky Monkey Bars® are tight and secure.
- Ensure all tubes are fully inserted into fittings until you hear the magic “CLUNK” sound.
- Ensure your Funky Monkey Bars® are properly secured at ALL times. Pegs are in place and inserted fully into the ground.
- DO NOT exceed the maximum load/weight limit as recommended by Funky Monkey Bars®.
- Children should be supervised by an adult at all times.
- Installing a gym/crash mat under the fall zone area of your Funky Monkey Bars® would be recommended for children learning this new skill. This will reduce the chance of injury and build the child’s confidence while they build strength and master the skill.
- Ensure you have thoroughly read your assembly and installation instructions and viewed our online installation videos at https://www.funkymonkeybars.com/blogs/installation-maintenance-videos.
- DO NOT climb, sit or stand on top of the monkey bar (horizontal ladder) section.
- DO NOT jump from the top of any section of the monkey bar.
- DO NOT use your Funky Monkey Bars® when wet,t as the steel will be slippery.
- DO NOT attach items to your frame that are not designed specifically to be used with Funky Monkey Bars®, especially lower-quality products that have not been approved by Funky Monkey Bars®.
- Ensure the height of your Funky Monkey Bars® (horizontal ladder) is set at a level that is age-appropriate.
- DO NOT install your Funky Monkey Bars® over or near objects that could interfere with users in an unsafe way. Maintain a clear area around your Funky Monkey Bars®.
- DO NOT use your Funky Monkey Bars® while under the influence of drugs and alcohol.
- Wear clothing free of drawstrings, hooks, loops or anything that could get caught while using your Funky Monkey Bars® and result in entanglement and/or strangulation.
ASSEMBLY
- Keep small children away from the Funky Monkey Bars® during assembly.
- Do not attempt to use the Funky Monkey Bars® until it is completely assembled and every fitting is tight and secured.
- Installation typically takes 1-2 hours to complete. Two people are recommended for assembly.
- Ensure all fittings are tightened to the correct tightening method as described on page 3.
- Assembly should be carried out on ca lean, dry, level surface
Please refer to the video section on the Funky Monkey Bars® website for more handy tips and assembly instructions at http://www.funkymonkeybars.com/pages/videos

LOCATION
- A safe fall zone around your Funky Monkey Bars® is essential. A minimum distance of 1.5m to 2m (5 ft to 6.5ft) is recommended around the elevated hanging points of your Funky Monkey Bars®.
- Place your Funky Monkey Bars® on level ground, away from any structure or obstruction such as a fence, garage, house, overhanging branches, laundry lines or electrical wires and remove any obstructions beneath your Funky Monkey Bars®.
- Ensure your Funky Monkey Bars® are positioned away from retaining walls, pool fences, structures and other play equipment. Maintain a clear space around the whole perimeter of your Funky Monkey Bars®.
- Place your Funky Monkey Bars® on the most level surface available.
MAINTENANCE
- At the beginning of each heavy play session, we recommend the following maintenance processes be performed on your Funky Monkey Bars®:
- Tighten all bolts, grub screws and applicable hardware (as per page 3)
- Lubricate all metallic moving parts as per instructions (flying fox, swing hook,s e.tc.)
- Check all protective coverings on bolts, pipes, edges and corners. Replace if they are loose, cracked or missing.
- Check all moving parts, including swing seats, shackles, snap hooks, chains and trolleys for wear, rust, or other deterioration. Replace as needed.
- Twice a month during the play season,n we would recommend the following maintenance processes be performed on your Funky Monkey Bars®:
- Tighten all connections and hardware
- Check all protective coverings on bolts, pipes, edges and corners. Replace if they are loose, cracked or missing.
- Once a month during play season, we would recommend the following maintenance processes be performed on your Funky Monkey Bars®:
- Lubricate all metallic moving parts as per instructions (flying fox, swing hook, etc.c). If the swings start to squeak, then lubricate the swing hooks.
- Check all moving parts, including swing seats, ropes, chains and trolleys,s for wear, rust, or other deterioration. Replace as needed.
- Owners shall be responsible for maintaining the legibility of any warning labels.
For additional information concerning your Funky Monkey Bars®, please contact our customer service team or check our website for any important updates. Phone – 1300 912 198 or www.funkymonkeybars.com
ASSEMBLY TIPS

TOOLS REQUIRED FOR INSTALLATION
FITTINGS
TUBES
Installation

- Tighten all hardware – grub screws, nuts and bolts.
- Pegs are in place and fully secure.
- Lubricate all metallic moving parts with WD40 or Vaseline – (trolley and swing hooks)
- Ensure your frame is level and square.
For more information and assembly tips,s please refer to our website video instruction section at http://www.funkymonkeybars.com/pages/videos
Contact Information
- 72 164 496 520
- 1300 912 198
- info@funkymonkeybars.com
- www.funkymonkeybars.com
- 8/307 Stock Road, O’Connor,W A 6163
FAQs
Documents / Resources
![]() | Swing Set |
References
- User Manualmanual.tools
Published: March 17, 2026

