Wattive TM12 Countdown Timer Socket User Manual

Wattive TM12 Countdown Timer Socket

Spécifications du produit

• Vol de travailtage: 230V
• Fréquence de travail : 50 Hz
• Courant max. : 16A
• Max. Puissance de charge: 3680 W
• Précision: +/- 1%

Instructions d'utilisation du produit

1. Réglage du compte à rebours :
   • Appuyez brièvement sur le ENSEMBLE key to cycle through the available countdown times.
   • The available countdown times are: 10m, 20m, 30m, 40m, 50m, 1h, 2h, 4h, 6h, 8h, 10h, 12h.
2. Démarrage du compte à rebours :
   • Une fois le compte à rebours souhaité réglé, appuyez sur MARCHE/ARRÊT key to start the countdown.
   • The timer will count down from 0 until the set time is reached, then it will automatically stop.
3. Stopping the Countdown Manually:
   To stop the countdown before it completes, press the MARCHE/ARRÊT touche à nouveau.

Dépannage du produit

• Le minuteur ne démarre pas : Ensure that a countdown time has been set using the ENSEMBLE clé. La MARCHE/ARRÊT key is invalid if no countdown time is set.
• Unable to change countdown time during operation: Le ENSEMBLE key is invalid while the countdown is running. Stop the countdown first by pressing MARCHE/ARRÊT, then set a new time.

OPÉRATION

• Short-press the “SET” key to set the countdown time.
• Set the countdown time by following: 10m-20m-30m-40m-50m-1h-2h-4h-6h-8h-10h-12h
• Press the ON/OFF to start the countdown from 0 till the set time is reached, then it stops automatically.
• Press the ON/OFF key again, and the countdown stops.
• Note: Pressing the SET key is invalid during the countdown time. Pressing the ON/OFF key is invalid if the countdown time is not set.

AFFICHER

• The indicator light will flash during the countdown time if it is working.
• The indicator light will be turned OFF when the countdown stops

SPÉCIFICATION

• Vol de travailtage: 230V
• Fréquence de travail : 50 Hz
• Courant max.: 16A
• Max. LoadPower: 3680 W
• Precision: +/- 1%

Questions fréquemment posées

How do I know if the countdown is active?
The indicator light will flash while the countdown time is working.

What happens when the countdown finishes?
The timer will automatically stop, and the indicator light will turn OFF.

Can I change the countdown time while it’s running?
No, you cannot. You must stop the current countdown first by pressing the MARCHE/ARRÊT key, and then you can set a new time using the ENSEMBLE clé.