Leadfan 9-inch Wireless CarPlay & Android Auto Car Stereo

1. Introduction

Thank you for choosing the Leadfan 9-inch Wireless CarPlay & Android Auto Car Stereo. This manual provides detailed instructions for installation, setup, operation, maintenance, and troubleshooting to ensure optimal performance and user experience. Please read this manual thoroughly before installation and use, and keep it for future reference.

2. Consignes de sécurité

• Débranchez toujours la borne négative de la batterie du véhicule avant de commencer toute installation électrique afin d'éviter les courts-circuits et les dommages électriques.
• Assurez-vous que tous les raccordements électriques sont bien fixés et correctement isolés afin d'éviter tout risque électrique.
• N’utilisez pas l’appareil d’une manière qui vous distrait de la conduite. La sécurité routière doit toujours être votre priorité.
• Consult a professional if you are unsure about any installation steps or encounter difficulties.
• This product is designed for Nissan Altima models from 2013-2018. Verify compatibility with your vehicle before installation.

3. Contenu du colis

Le forfait comprend les éléments suivants :

• 9-inch IPS Touchscreen Android Radio Headunit
• Frame for Nissan Altima Teana 2013-2018
• Caméra de recul AHD
• Câble d'entrée pour caméra de recul
• Câble RCA
• Câble USB (x2)
• Câble d'alimentation
• Antenne GPS
• Décodeur CanBus
• Microphone externe
• Supports de montage
• Adaptateur radio
• Manuel d'utilisation

4. Configuration et installation

Cette section vous guide tout au long du processus d'installation. Pour un guide visuel, veuillez consulter la vidéo d'installation ci-dessous.

1. Disconnect Ground Cable: Open the hood and disconnect the negative terminal from the car battery. Use a 10mm socket or pliers if it's a wing nut.
2. Remove Instrument Side Finisher: Using a trim removal tool, gently pry away the instrument side finisher on the driver's side until it detaches.
3. Unseat Instrument Lower Panel: Use a trim removal tool to unseat the lower instrument panel on the driver's side.
4. Remove Center Stack Side Finishers: Carefully pry off the two side finishers located next to the factory radio using a trim removal tool.
5. Remove Front Air Control Screws: Locate and remove the two Phillips head screws securing the front air control panel.
6. Remove Front Air Control: Gently pull the front air control panel to detach it.
7. Disconnect Front Air Control Harness: Disconnect the single wiring harness from the back of the front air control panel.
8. Remove Cluster Lid (C) Screws: Remove the two Phillips head screws for the cluster lid (C).
9. Remove Cluster Lid (C): Gently pull the cluster lid (C) to detach it.
10. Disconnect Cluster Lid (C) Harness: Disconnect the two wiring harnesses from the back of the cluster lid (C). Needle nose pliers may be helpful.
11. Remove Audio Unit Screws: Remove the four Phillips head screws securing the factory audio unit.
12. Remove Audio Unit: Gently pull the factory audio unit out of the dashboard.
13. Disconnect Audio Unit Harness: Disconnect the four wiring harnesses from the back of the factory audio unit.
14. Install Brackets to Screen Frame: Attach the provided mounting brackets to the new head unit's screen frame using the included screws and screwdriver.
15. Connect RCA AUX IN: Connect the red and white RCA auxiliary input cables to the corresponding ports on the new head unit.
16. Connect CAN-BUS Module: Connect the CAN-BUS module to its designated white connector on the main wiring harness.
17. Connect Reverse Camera Input: Connect the yellow RCA cable for the reverse camera input.
18. Connecter l'antenne GPS : Screw in the GPS antenna to its port on the head unit.
19. Install Harness Connections: Connect the remaining seven harness connections (USB, main antenna, steering wheel controls, power) to their specific ports on the new head unit. These are keyed to fit only one way.
20. Connect Harness to Factory Plugs: Connect the new head unit's main wiring harness to the four factory plugs in the vehicle's dashboard.
21. Run USB Cables: If desired, feed the two USB cables through a small opening in the dashboard to a convenient location for access.
22. Attach GPS Antenna to Surface: Remove the adhesive liner from the GPS antenna and stick it to a clean, flat surface behind the radio for optimal signal reception.
23. Install New Car Stereo: Carefully slide the new head unit into the dashboard opening and push firmly until it snaps securely into place.
24. Reinstall Cluster Lid (C): Reconnect the wiring harnesses to the cluster lid (C) and snap it back into position.
25. Reinstall Front Air Control: Reconnect the wiring harness to the front air control panel and snap it back into place, ensuring it aligns correctly.
26. Install Cluster Lid/Air Control Screws: Reinstall the four Phillips head screws for the cluster lid and front air control.
27. Install Center Stack Side Finishers: Snap the two center stack side finishers back into place, starting from the top and working your way down.
28. Reseat Instrument Lower Panel: Push the instrument lower panel back into its original position until it snaps.
29. Install Instrument Side Finisher: Push the instrument side finisher back into its original position until it snaps.
30. Reconnect Ground Cable: Reconnect the negative terminal to the car battery and tighten it securely.
31. Setup CAM-BUS: After powering on the unit, navigate to Settings > Factory. Entrer le mot de passe 3368 and confirm. Then go to Car Model > RZC > Nissan > All > All to configure the CAN-BUS settings.
32. Tester toutes les fonctions : Verify that all functions, including steering wheel controls, phone, and voice commands, are working correctly.

5. Mode d'emploi

Description de l'image : The car stereo screen displaying the Wireless CarPlay and Android Auto interfaces, showing various app icons like Phone, Music, Maps, Messages, and Spotify. A smartphone is shown wirelessly connected to the system.

Description de l'image : A visual representation of wireless connection for Apple CarPlay and Android Auto, showing a smartphone connecting to the car stereo via WiFi and Bluetooth.

• CarPlay et Android Auto sans fil : Connect your smartphone wirelessly via Bluetooth and Wi-Fi. Use the pre-installed 'Zlink' app to access phone features like navigation, calls, messages, and music directly on the car stereo screen. Supports voice control via Siri/Google Assistant.
• Lien miroir : Project your phone screen onto the car stereo. iOS supports wireless connection, while Android supports both wireless and wired connections.
• Navigation GPS: The unit comes with a built-in offline map application for North America. Connect to Wi-Fi or a hotspot to access online maps and other navigation apps from the Play Store (e.g., Maps, Sygic, Navitel IGO).
  

  Description de l'image : The car stereo screen displaying GPS navigation with map routes and a separate section showing various app icons available via 5G WiFi connection.

• Bluetooth 5.1: Enjoy hands-free calling and wireless music streaming. The unit includes a built-in clear microphone and an external mic jack for enhanced call quality.
• Radio FM: Access stable FM radio with unlimited preset stations and support for manual and automatic station search.
• Commandes au volant (SWC) : The unit supports your original car's steering wheel control buttons, allowing you to easily switch songs, change channels, and adjust volume for safer driving.
  

  Description de l'image : The car stereo screen showing a 1280*720P AHD backup camera view, alongside an image demonstrating the use of steering wheel controls to manage radio functions.

• Caméra de recul : The included IP68 AHD rear camera provides a 1280*720P image with a 170-degree ultra-wide angle. The display automatically switches to the rear view en marche arrière.
• Écran partagé : Display two applications simultaneously on the screen for multitasking.
• Connexion Wi-Fi : Connect to wireless networks or use your phone's hotspot to download additional applications from the Google Play Store, such as YouTube, Spotify, or Pandora.
• Effets sonores EQ : Adjust various EQ sound effects to customize your audio experience.

6. Entretien

• Nettoyage de l'écran : Utilisez un chiffon doux non pelucheux pour essuyer délicatement l'écran tactile. Pour les traces tenaces, frottez légèrement.ampNettoyez le chiffon avec de l'eau ou un nettoyant adapté aux écrans. Évitez les produits chimiques agressifs.
• Nettoyage général : Keep the unit and surrounding dashboard area free of dust and debris. Use a soft brush or cloth for vents and crevices.
• Mises à jour logicielles : Periodically check for software updates from Leadfan to ensure optimal performance and access to new features.

7. Dépannage

• Wireless CarPlay/Android Auto Not Working: Try restarting your smartphone and the car stereo. Ensure Bluetooth and Wi-Fi are enabled on your phone and correctly paired with the unit. If using a wired connection for Android Auto, use the original USB cable.
• Pas de son : Check all audio connections, including RCA cables. Verify the volume levels on both the car stereo and your connected device.
• Problèmes de signal GPS : Ensure the GPS antenna is securely attached and placed in a location with a clear view du ciel, libre de tout obstacle.
• L'unité ne s'allume pas : Check the battery connection and all power harnesses. Ensure the vehicle's ignition is on.
• Commandes au volant ne répondant pas : Verify the CAN-BUS settings are correctly configured as per the setup instructions (Settings > Factory > PW: 3368 > Car Model > RZC > Nissan > All > All).

8. Spécifications

9. Garantie et assistance

• Assurance qualité: This product comes with a 1-Year Quality Assurance.
• Politique de retour: A 30-Day Return Policy is available for your convenience.
• Support technique : Leadfan offers Lifetime After-Sales Consult and Technical Support.
• Service client: For any technical or installation questions, please contact "Leedfan" via Amazon chat. We aim to reply within 16 hours.