formlabs White Resin V5 Owner's Manual

SOLVENT COMPATIBILITY

Percent weight gain over 24 hours for a printed 1 x 1 x 1 cm cube immersed in respective solvent:

1. Material properties may vary based on part geometry, print orientation, print settings, temperature, and disinfection or sterilization methods used.
2. Data was obtained from parts printed on a Form 4 printer with 100 µm White Resin V5 settings, washed in a Form Wash for 5 minutes in 99% Isopropyl Alcohol, and post-cured at room temperature for 5 minutes in a Form Cure.
3. Data was obtained from parts printed on a Form 4 printer with 100 µm White Resin V5 settings, washed in a Form Wash for 5 minutes in 99% Isopropyl Alcohol, and post-cured at 60°C for 15 minutes in a Form Cure.

Documents / Resources

formlabs White Resin V5 [pdf] Owner's Manual V5 FLGPWH05, White Resin V5, Resin V5, V5, Resin

References

• User Manual