formlabs Clear Resin V5 Form 4 3D Printer User Guide
SOLVENT COMPATIBILITY
Percent weight gain over 24 hours for a printed and post-cured 1 x 1 x 1 cm cube immersed in respective solvent:
- Material properties may vary based on part geometry, print orientation, print settings, temperature, and disinfection or sterilization methods used.
- Data was obtained from parts printed on a Form 4 printer with 100 µm Clear Resin V5 settings, washed in a Form Wash for 5 minutes in 99% Isopropyl Alcohol, and post-cured at room temperature for 5 minutes in a Form Cure.
- Data was obtained from parts printed on a Form 4 printer with 100 µm Clear Resin V5 settings, washed in a Form Wash for 5 minutes in 99% Isopropyl Alcohol, and post-cured at 60°C for 15 minutes in a Form Cure.
Documents / Resources
 |
formlabs Clear Resin V5 Form 4 3D Printer [pdf] User Guide V5 FLGPCL05, Clear Resin V5 Form 4 3D Printer, Clear Resin V5, Form 4 3D Printer, 3D Printer, Printer |