Ford Tail Gate Protector
INSTALLATION STEPS
- Clean and dry the installation area making sure the surface is clean dry and free of wax.
- Place the product in a suitable installation location Make sure the arcs match.
- Recommend installing under 30′ sunshine, hot gun or hair dryer to preheat the automotive adhesive tapeе tape before to peel.
- Peel remaining tape liner by pulling on the exposed end of the liner. Don’t wash the car within 24 hours please.
Attention:
- If there is a lining inside the car (as shown in picture A),
- the tail gate protector to be trimmed (as shown in picture B)
- before it can be installed successfully (as shown in picture C)
Attention: The design of different models may vary, please refer to the actual product.
Specifications
| Feature | Description |
|---|---|
| Installation Type | Easy Stick on Fitment |
| Tools Required | Hot gun or hair dryer (optional) |
| Surface Preparation | Clean, dry, and wax-free |
| Post-Installation Care | Avoid washing the car for 24 hours |
FAQs
- Do I need to drill holes for installation?
- No, drilling is not required. The protector uses adhesive tape for installation.
- Can I install the protector in cold weather?
- It is recommended to install under 30° sunshine or use a hot gun or hair dryer to preheat the adhesive tape.
- Why should I avoid washing the car after installation?
- The adhesive needs time to set properly, so avoid washing the car for 24 hours post-installation.
Documents / Resources
 | Tail Gate Protector |
References
- User Manualmanual.tools
Published: June 19, 2025