FORCE HAL Helmet
Specifications
- Brand: HAL
- Model: CZ
- Origin: Wenling City, Zhejiang, China
Product Usage Instructions
- INSTRUCTIONS FOR USE
- This is a helmet for cyclists protecting the top of the user’s head. Suitable for cycling or scooter riding.
- This product is personal protective equipment whose primary function is to protect the top of the user’s head from hazards that may arise during cycling and scooter riding activities.
- The device protects the head from impacts where part of the impact energy is absorbed by the helmet, thereby reducing the impact energy to which the head is exposed.
- The protection provided by the helmet depends on the circumstances surrounding the injury and cannot always protect against injury.
- The helmet only protects if it is well seated on the head. The buyer must try on different sizes and choose a helmet that ts his or her head securely and comfortably.
- With the help of spare padding (not applicable for integral helmets), the internal size can be adjusted to the optimum shape.
- The helmet must be adapted to the user. Correct routing of the strap under the chin without covering the ears is essential.
- The buckle, when properly adjusted, should t snugly and comfortably under the chin (away from the jaw) so that the helmet stays on the head in the event of a fall.
- The straps and buckle must be comfortably and rmly adjusted. The helmet must not be worn too far back and must t to protect the front of the head.
- Original helmet components must not be removed or altered under any circumstances. Do not expose the helmet to temperatures exceeding 60°C, and do not clean it with synthetic agents (lukewarm water is sufficient).
- Helmets damaged by a fall must no longer be used! The helmet must not be used for activities other than those for which it is intended (do not use it when riding a motorcycle)!
- Warning! This helmet is not to be used by children when climbing and other activities in which there is a risk of strangulation/hanging by the helmet in the event of a child falling!
- Never pull over the stop when adjusting the wheel! If the helmet has been subjected to a severe impact the damaged piece must be replaced and disposed of. Select the correct helmet size according to the head circumference in cm.
- The above also applies to integral cycle helmets of their construction and specication.
- We declare that this cycle helmet complies with Regulation (EU) 2016/425 of the European Parliament and of the Council of 9 March 2016 on personal protective equipment.
- Notied Body involved in the conformity assessment of PPE; SGS Fimko Ltd., Takomotie 8, FI-00380, Helsinki, Finland;
- TR: GZHL2309031246HM-1. The current Declaration of Conformity can be found on the website www.force.bike in the “Documents to download” section for the product concerned.
- Importer: KCK Cyklosport-Mode s.r.o., Bartošova 348, 765 02 Otrokovice-Kvítkovice, Czech Republic.
- Correct t of the helmet (points 1 and 2 do not apply to integral helmets):
- Look upwards to make sure you can only see the edge of the helmet.
- The side straps should be attached just below the ears, in the shape of a ‘Y’.
- When you fasten the strap and open your mouth wide, you should feel the helmet pulling down.
FAQs
- Q: How do I know if the helmet fits correctly?
- A: To ensure a proper fit, follow the instructions provided in the manual. Make sure you can only see the edge of the helmet when looking upwards, attach the side straps in a ‘Y’ shape just below the ears, and feel the helmet pulling down when fastening the strap and opening your mouth wide.
Documents / Resources
 |
FORCE HAL Helmet [pdf] Instruction Manual HAL Helmet, HAL, Helmet |
