FENIX TK61 Flashlight User Guide

FENIX logoFenix TK61 Flashlight

The Fenix TK61 is scaled for extended operation in challenging conditions with 1000-lumen max output. Utilizing a single CREE XM-L2 U2 LED, the TK61 employs dual on-body switches for rapid shifting between four brightness levels and two flashing modes, with runtime well beyond 4hrs on Turbo. The 824m throw reaches deep while an extended runtime kit stays the course whether the TK61 is handheld, shoulder-strap carried, or vehicle-mounted

FENIX TK61 Flashlight

  • Uses Cree XM-L2 U2 LED with a lifespan of 50000 hours
  • Uses four 18650 rechargeable Li-ion batteries or eight 3V CR123A Lithium batteries
  • 216mm (Length) x 52.5mm (Diameter) x 96mm(Head)
  • 600-gram weight (excluding batteries)
  • Digitally regulated output – maintains constant brightness
  • Reverse polarity protection, to protect from improper battery installation
  • Dual switch system in the front, simple and fast operation
  • Made of durable aircraft-grade aluminum
  • Premium Type III hard-anodized anti-abrasive finish
  • Toughened ultra-clear glass lens with anti-reflective coating

Technical Parameters

ANSI/NEVA FL 1 General Mode Strobe SOS
Turbo High Mid Low
OUTPUT :000 Lumens -1:4: Liirvelit 130 Lumens 20 Lumens 1000 Lunn 130 Lumens
RUNTIME 4h 2Ornin 14h 46h 300h
DISTANCE 824m (Max)
INTENSITY 170000cd (Max)
IMPACT RESISTANT 1m
WATERPROOF IPX-8, underwater 2m
ACCESSORIES Lanyard, shoulder strap and spate 0-ring

Operation

Dual Switches
The right button switch with a power source mark is the power switch. The left button switch with a recycling symbol is the mode switch.
On/Off
A single press on the power switch turns the TK61 on or off.
Brightness Levels and Modes
With the light on, a single press on the mode switch allows switching between Turbo, Low, Mid→High brightness levels.
To activate the Strobe mode, press and hold the mode switch for about one second. It will flash at the frequency of 6Hz or 15 Hz every 2 seconds.
To activate the SOS mode, press and hold the mode switch for about three seconds.
While in Strobe or SOS mode, a single press on the mode switch returns the TK61 to the non-flashing mode.
Instant Strobe
With the light off, press and hold the mode switch for about one second to activate the Strobe mode.
Instant Turbo
With the light off, press and hold the power button for one second to activate maximum output until the button is released and the TK61 returns to the previous brightness level.
Memory Circuitry
The Fenix TK61 memorizes the last brightness level used in the general mode. The next time you turn the flashlight on, it will activate the last brightness level you selected. However, whether the light is on or off, it will enter Strobe or SOS mode simply by pressing and holding the mode switch.

Battery Specifications

Type Dimensions Nominal voltage Usability
Fenix ARB-L2 18650 3.7V Recommended FENIX TK51 Flashlight - Icon
Fenix ARB-L2S 18650 3.6V Recommended FENIX TK51 Flashlight - Icon
Non-rechargeable Battery (Lithium) CR123A 3V Usable FENIX TK51 Flashlight - Icon
Rechargeable Battery (Li-ion) 16340 3.7V Banned FENIX TK61 Flashlight - Icon
Rechargeable Battery (Li-ion) 18650 37V Cautious !
Rechargeable Battery (LiFePO4) 18340 3.2V Banned FENIX TK61 Flashlight - Icon
Rechargeable Battery (LiFePO4) 18650 3.2V Usable FENIX TK51 Flashlight - Icon

Warning: Please do not mix batteries of different brands, sizes, capacities, or types. Doing so may cause damage to the flashlight or the batteries being used. “Please do not use the banned batteries, or it will cause damage to the flashlight.
*18650 Li-ion batteries are powerful cells designed for commercial applications and must be treated with caution and handled with care. Quality batteries with circuit protection will reduce the potential for combustion or explosion, but cell damage or short circuiting are potential risks the user assumes.

Battery Replacement

Unscrew the tail cap to take out the battery holder, and then insert four batteries with the negative terminal towards the spring. After loading the batteries into the holder, insert the holder with its top spring towards the LED assembly. Screw the tail cap on with all of the threads in proper alignment.

Usage & Maintenance

  • Please don’t disassemble the sealed head, as doing so can cause damage to the flashlight and will void the warranty.
  • We recommend the use of high-quality batteries. If the flashlight is not to be used for an extended period, remove the batteries, or the flashlight could be damaged by electrolyte leakage or battery explosion.
  • Unscrew the tail cap one-half turn or take out the battery to prevent accidental activation during storage or transport.
  • The circuit is programmed with a low-voltage protection function. If low voltage is detected, it will enter a lower brightness level. If low voltage is detected in the Low brightness level, it will blink three times a second every 5 minutes. To ensure normal use, TK61 will not turn off automatically and will work until the batteries run out completely.
  • When absolutely necessary, the flashlight can be powered by two 18650 rechargeable Li-ion batteries.
    Unscrew the tail cap to take out the battery holder and insert the batteries into the adjacent battery compartment in the opposite direction (which can form a battery circuit), with the negative terminal toward the spring. Replace the battery holder and screw the tail cap back on.
    Note that runtimes will be shorter and battery life will likely be reduced.

FENIX TK61 Flashlight - Fig1

  • When absolutely necessary, the flashlight can be powered by four or eight CR123A batteries.
    Unscrew the tail cap to take out the battery holder and insert the batteries with the negative terminal toward the spring (when using four batteries, insert the batteries into the adjacent battery compartment in the opposite direction to form a battery circuit). Replace the battery holder and screw the tail cap back on.
    In this case, the TK61will run at a low brightness level, and the mode switch will be disabled.
  • The TK61’s runtime can be extended with the addition of each ARB-L5 rechargeable battery pack or AER-TK75 runtime-extended kit. Runtime will double with each ARB-L5 or AER-TK75 addition, but brightness levels will not be altered.

FENIX TK61 Flashlight - Fig2

  • The TK61 can use the AEU-43 USB kit, including the Micro USB charging port, standard USB port, and power indication function. ARB-L5 rechargeable battery pack or an AER-TK75 runtime-extended kit can be exchanged or used in combination with the TK61’s body and battery holder, and in this case, the AEU-43 USB kit can also charge the ARB-L5 rechargeable battery pack.

FENIX TK61 Flashlight - Fig3

NON ABU-43 158 will not charge the rechargeable batteries in the battery holder.

  • The O-ring may be worn out after using for a long time. If this happens, please replace the O-ring to keep the flashlight properly sealed against water
  • Periodic cleaning of the battery contacts improves the flashlight’s performance, as dirty contacts may cause the flashlight to flicker, shine intermittently, or even fail to illuminate for the following reasons:
    Reason A. The batteries need replacing.
    Solution: Replace the batteries (Please confirm the correct installation of anode and cathode).
    Reason B: The threads, PCB board contact, or other contacts are dirty.
    Solution: Clean the contact points with a cotton swab soaked in rubbing alcohol.
    If the above methods don’t work, please refer to the warranty policy before contacting your authorized distributor

Product Warranty

We will replace products afflicted with manufacturing defects within 15 days of purchase and repair a light free of charge within 24 months of purchase if problems develop with normal use; if repair is required after 24 months from the date of purchase, we will charge for parts. The total repair fee is dictated by the cost of the replaced materials.

Product Registration

We kindly suggest that you register your product on the official website of Fenixlight Limited (www.fenixlight.com). You’ll receive an extra six months of warranty coverage once you have successfully registered. By participating in an optional customer survey, you are entered in a drawing for free Fenix products.
Warning
TK61 is a high-intensity lighting device and is capable of causing eye damage; avoid shining the light directly into the eyes.

FENIX logo

Documents / Resources

PDF thumbnailTK61 Flashlight
User Guide · TK61 Flashlight, TK61, Flashlight

References

Ask a Question

Use this section to ask about setup, compatibility, troubleshooting, or anything missing from this manual.

Ask a Question

Ask about setup, compatibility, troubleshooting, or anything missing from this manual. Name and email are optional.