FENIX TK47 Flashlight Instruction Manual

FENIX-LOGO

FENIX TK47 Flashlight

FENIX-TK47-Flashlight-PRODUCT

Overview

The Fenix TK47 Ultimate Edition is a dual-source flashlight featuring a Cree XHP70 LED headlight (up to 3200 lumens, 408 m max beam distance) and a tail light with white/red outputs. It supports independent control of headlight and tail light, regulated output, a lockout function, overheat protection, and low-voltage downshift.

Specifications

Headlight LED Cree XHP70 (rated lifespan: 50,000 hours)
Max Lumens (Headlight) 3200 lumens
Max Beam Distance (Headlight) 408 m
Tail Light White LED, red LED, diffuser tip design
Power Two 18650 rechargeable Li-ion batteries
Dimensions 266.2 mm (length) x 61.5 mm (head diameter) x 28.6 mm (body diameter)
Weight 365 g (excluding batteries)
Dual Light Sources Two independent light sources can be used simultaneously
Regulation Digitally regulated output maintains constant brightness
Beam/Output & Runtime (ANSI/PLATO FL1) Turbo 3200 lm / 1h*; High 1000 lm / 3h 20min; Med 350 lm / 10h 20min; Low 100 lm / 46h; Eco 20 lm / 170h
Tail Light Output & Runtime (ANSI/PLATO FL1) White 3200 lm / 43h 30min; Red 30 lm / 150h; Red flash 1.5 lm / 1.5 lm; Red SOS 1.5 lm / 1.5 lm
Distance (Headlight) Turbo 408 m; High 250 m; Med 120 m; Low 65 m; Eco 31 m
Impact Resistance 1 m
Water Resistance IP68 (underwater 2 meters)
Accessories Lanyard, Holster, spare O-ring

Note: Parameters are lab-tested by Fenix using two 3.6V/3500mAh rechargeable 18650 Li-ion batteries and may vary by flashlight, batteries, and environment.

  • Max 3200 Lumens
  • Dual-Purpose & High-Performance
  • Max 408 Meters Beam Distance

FENIX-TK47-Flashlight-FIG-1

Key Features

  • Headlight: Cree XHP70 LED with a lifespan of 50,000 hours
  • Tail light: Quality white LED, red LED, and diffuser tip design
  • Power: Powered by two 18650 rechargeable Li-ion batteries
  • Dimensions: 266.2mm Length x 61.5mm Head Diameter x 28.6mm Body Diameter
  • Weight: 365 grams (excluding batteries)
  • Dual independent light sources that can be used simultaneously
  • Headlight with a high output of 3200 lumens and 408m beam distance
  • Digitally regulated output maintains constant brightness
  • The headlight features a lockout function
  • Reverse polarity protection to protect from improper battery insertion
  • Intelligent overheat protection to avoid high surface temperatures
  • Featuring a low-voltage downshift function
  • Made of durable aircraft-grade aluminum
  • Premium type III hard-anodized anti-abrasive finish
  • Toughened ultra-clear glass lens with an anti-reflective coating

Battery Specifications

TYPE DIMENSIONS NOMINAL VOLTAGE USABILITY
Fenix ARB-L18 Series 18650 3.6V/3.7V Recommended
Rechargeable Battery (Li-ion) 18650 3.6V/3.7V Cautious*

Warning:

  1. Do not mix batteries of different brands, sizes, capacities, or types. Doing so may cause damage to the flashlight or the batteries being used.
  2. CR123A batteries can be used in an emergency, though the output will downshift slightly.

*18650 Li-ion batteries are powerful cells designed for commercial applications and must be treated with caution and handled with care. Quality batteries with circuit protection will reduce the potential for combustion or explosion, but cell damage or short-circuiting remain potential risks assumed by the user.

Operation Instructions

  • ON/OFF:
    • In unlocked status, press and hold the side switch for 0.5 seconds to turn the headlight on/off.
    • Press and hold the tail switch for 0.5 seconds to turn the tail light on/off.
  • Output Selection:
    • Headlight: When the headlight is on, single-click the side switch to cycle through: Turbo → Eco → Low → Med → High.
    • Tail light: When the tail light is on, single-click the tail switch to cycle through: White light → Red light → Red flash → Red SOS.
  • Strobe: In unlocked status, press and hold the tail switch for 1.5 seconds to activate Strobe. Single-click the side switch to return to general brightness.
  • Lockout Function:
    • Lock: When the headlight is off and unlocked, double-click the side switch. The light will blink twice at Low output to indicate it is locked.
    • Unlock: When the headlight is off and locked, double-click the side switch. The light will unlock and turn on in the last used output level.
    • Note: In locked status, the light only responds to the unlock operation. Single-clicking the side switch will cause the headlight to blink twice as a reminder that it is locked.

Specialized Functions

  • Intelligent Memory Circuit
    The headlight memorizes the last brightness level used in General mode. The next time it is turned on, it will recall that previously used brightness level. The tail light defaults to white light each time it is turned on.
  • Intelligent Overheat Protection
    The light will accumulate significant heat when used at the Turbo output level for extended periods. When the light reaches a temperature of 65 °C or above, it will automatically step down by a few lumens to reduce temperature. Once the temperature has lowered, the output will gradually return to the Turbo output level.
  • Low-Voltage Downshift Function
    When the voltage level drops below the preset limit while operating, the flashlight will downshift to lower brightness levels until Low output is reached to remind you to replace the batteries. To ensure safety and utility, the light will not turn off completely and will work until the battery over-discharge protection stops operation.

ANSI / PLATO FL1 Technical Specifications

FENIX-TK47-Flashlight-FIG-3

Notice: The above-mentioned parameters (lab-tested by Fenix using two 3.6V/3500mAh rechargeable 18650 Li-ion batteries) may vary between flashlights, batteries, and environments.

*Due to the intelligent overheat protection, the runtime of Turbo is estimated.

**Tail light features a wide-range beam diameter.

Usage and Maintenance

  • Disassembling the sealed head can cause damage to the light and will void the warranty.
  • Fenix recommends using high-quality batteries.
  • If the light will not be used for an extended period, remove the batteries, or the light could be damaged by electrolyte leakage or battery explosion.
  • Long-term use can result in O-ring wear. To maintain a proper water seal, replace the ring with an approved spare.
  • Periodic cleaning of the battery contacts improves the lamp’s performance. Dirty contacts may cause the lamp to flicker, shine intermittently, or fail to illuminate. If performance is compromised, check the following:
    • Reason A: The batteries need replacing. Solution: Replace batteries (Ensure they are inserted according to polarity markings).
    • Reason B: The threads, PCB board contact, or other contacts are dirty. Solution: Clean the contact points with a cotton swab soaked in rubbing alcohol.

    If the above methods do not resolve the issue, please refer to the warranty policy before contacting your authorized distributor.

Battery Replacement

Unscrew the tail cap to insert the batteries with the anode side (+) facing toward the light head, then screw the tail cap back on.

Safety Warning

The flashlight is a high-intensity lighting device capable of causing eye damage to the user or others. Avoid shining the flashlight directly into anyone’s eyes.

FENIX-TK47-Flashlight-FIG-2

FENIXLIGHT LIMITED

Tel: +86-755-29631163/83/93 | Fax: +86-755-29631181 Web: www.fenixlight.com | E-mail: info@fenixlight.com Address: 8/F, 2nd Building, DongFangMing Industrial Center, 33rd District, Bao’an, Shenzhen 518133, China

61.122.391.014-A0-201612

Troubleshooting

If the light’s performance is compromised (e.g., it flickers, shines intermittently, or fails to illuminate):

  • Reason A: The batteries need replacing.
    Solution: Replace batteries, ensuring they are inserted according to polarity markings.
  • Reason B: The threads, PCB board contact, or other contacts are dirty.
    Solution: Clean the contact points with a cotton swab soaked in rubbing alcohol.
  • If the above does not resolve the issue: Refer to the warranty policy before contacting your authorized distributor.
  • Additional maintenance guidance: Periodic cleaning of the battery contacts can improve performance. If the flashlight will not be used for an extended period, remove the batteries (to reduce risk of damage from electrolyte leakage or battery explosion).

Documents / Resources

PDF thumbnailTK47 Flashlight
Instruction Manual · TK47 Flashlight, TK47, Flashlight

References

Ask a Question

Use this section to ask about setup, compatibility, troubleshooting, or anything missing from this manual.

Ask a Question

Ask about setup, compatibility, troubleshooting, or anything missing from this manual. Name and email are optional.