FENIX E11 Flashlight Instruction Manual

Technical Parameters

Key Features

• Uses Cree XP-E LED with a lifespan of 50,000 hours
• Uses one 1.5V AA (Ni-MH, Alkaline) battery
• 97mm (Length) * 19mm (Diameter)
• 32-gram weight (excluding the battery)
• Digitally regulated output – maintains constant brightness
• Reverse polarity protection, to protect from improper battery installation
• Tactical tail switch with momentary-on function
• Made of durable aircraft-grade aluminum
• Premium Type III hard-anodized anti-abrasive finish
• High-efficiency total reflection lens

Note: The above-mentioned parameters (tested by 2500mAh Ni-MH battery in the lab) are approximate and may vary between flashlights, batteries, and environments.

Operation Instruction

• Press the tail switch lightly to activate the light. Press the switch completely to turn on the light and lock it. Another complete press on the switch will turn it off.
• To select between the high brightness level and the low brightness level, screw or unscrew the light head.

Battery Specifications

Battery Replacement

• Unscrew the light head to insert the battery with the anode (+) toward the light head, then screw the light head back on to test.

Usage and Maintenance

• Please don’t disassemble the sealed head, doing so can cause damage to the flashlight and will void the warranty.
• High-power lights should use batteries with high current discharge capability; We suggest using high-performance Ni-MH rechargeable batteries to increase the runtime of this high-intensity light.
• Please use high-quality batteries, and remove the battery if the flashlight will not be used for a long time, or it may cause damage from electrolyte leakage or battery explosion.
• The o-ring may wear out after long-term use. If this occurs, replace the o-ring with a new one to keep the light properly sealed against water.
• Please clean the contacts of your light periodically, especially if the light flickers or does not turn on. There may be several reasons for a flickering or non-working light: Reason A: The battery needs replacing. Solution: Replace the battery (Please confirm the correct installation of anode and cathode). Reason B: The threads, PCB board contact, or other contacts are dirty. Solution: Clean the contact points with an alcohol-soaked cotton swab.

If the above methods do not work, please contact your distributor and refer to the warranty policy.

Notice: The routine cleaning video can be watched and downloaded through the Fenix official website. Please log onto the service channel and navigate to ‘maintenance for light’.

Product Warranty

• We will replace products afflicted with manufacturing defects within 15 days of purchase and repair a light free of charge within 24 months of purchase if problems develop under normal use. If repair is required after 24 months from the date of purchase, we will charge for parts. The total repair fee is dictated by the cost of the replaced materials.

Warranty Card Registration

• We kindly suggest that you register your guarantee card on the official website for Fenixlight Limited. You can receive an extra six-month warranty period once you have successfully registered. In addition, you can take part in the questionnaire lottery at the same time.

Warning

• The E11 is a high-intensity lighting device capable of causing eye damage. Avoid shining the light directly into eyes.