FEIT ELECTRIC logo

Remote Controller
An instruction manual

FEIT ELECTRIC FEODRGBW Remote Controller

Product Parameters

Model No:FEODRGBW/REM
power supply: DC3.0V(2*1.5 Size”AAA”Battery)
Product size: L106xW48xH15mm
Working environment: indoor
Working temperature: – 10 C – 45 ℃ (140 F – 113 F)
Humidity: <80% RH

Warranty instructions

The one-year warranty of our products is only applicable to all operations that conform to the instructions.The warranty does not include the following:

  1. Any change, amendment, deletion or scribbled purchase labels or instructions.
  2. Failure due to damage, misuse.
  3. Because of the natural environment rather than the inherent causes of the product (such as lightning, flood, etc.).The bad phenomena of fire, etc.
  4. The product has been opened or disassembled.
  5. Adverse consequences arising from use, maintenance or custody do not conform to product specifications(e.g. damp, corrosive).
  6. Any other matter caused by product defect, appearance distortion, appearance damage or external forcePhysical injury.

NOTE

  1. Do not use in humid, high temperature environment.
  2. Please don’t use this product in bed.

FCC Statement

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

  • Reorient or relocate the receiving antenna.
  • Increase the separation between the equipment and receiver.
  • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
  • Consult the dealer or an experienced radio/TV technician for help.

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause  undesired operation.
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
RF Exposure Statement
The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.

Documents / Resources

FEIT ELECTRIC FEODRGBW Remote Controller [pdf] Instruction Manual
FEODRGBW Remote Controller, FEODRGBW, Remote Controller, Controller

References

Leave a comment

Your email address will not be published. Required fields are marked *