Farenhyt ECS-RVM Remote Voice Module User Manual

Farenhyt ECS-RVM Remote Voice Module

Contents hide

1 Remote Voice Module Product Installation Document

2 Customer Support

3 Documents / Resources

3.1 References

4 Related Posts

Remote Voice Module Product Installation Document

Description

The ECS-RVM Remote Voice Module is contained within the ECS-LOC or ECS-2100LOC Local Operator Console. It provides a supervised microphone for live communication and an interface for the Emergency Communication System.

NOTE: Installation and wiring of this device must be done in accordance with NFPA 72 and local ordinances.

Compatibility

The ECS-RVM is compatible with the following Honeywell Farenhyt
Series FACPs:

IFP-2100ECS
IFP-2000ECS

IFP-1000ECS
IFP-300ECS

IFP-100ECS

NOTE: For programming and DIP switch settings, refer to the FACP Manual.

Specifications

Standby Current: 60mA

Alarm Current: 80mA

Board Layout and Mounting

Open the cabinet door and the dead front panel.
Remove AC power and disconnect the backup batteries from the main control panel.

Mount the ECS-RVM in the middle section of the dead front on the six mounting studs. See Figure 1 for hole locations and Figure 4 for board mounting location.

Wiring to an FACP

Figure 2 belows shows how to properly wire the ECS-RVM to the FACP SBUS.

Figure 2 Wiring the ECS-RVM to the FACP

Installing the Microphone

Clip the microphone onto the microphone clip.
figure 4 Microphone Cord Inserted Through Dead Front Panel Hole
Insert microphone cord through hole at the bottom of the dead front panel.

Attach strain relief clip to microphone cord. The strain relief clip should have about 2.75” of microphone cord through it.
Figure 5 Installing Strain Relief Clip
Push the strain into the hole in the dead front panel.