1. مقدمه
This manual provides essential information for the safe and efficient installation, operation, and maintenance of your Ledvance LED Floodlight with Motion and Light Sensor. Please read these instructions carefully before installation and retain them for future reference.
The Ledvance LED Floodlight is a high-performance outdoor lighting solution featuring 41W power, 6000 lumens brightness, a 100-degree beam angle, and a cool white (4000K) light output. It is designed for outdoor use with an IP65 rating, ensuring protection against dust and water jets. Integrated motion and light sensors provide automated control for enhanced energy efficiency and security.
Image 1: Ledvance LED Floodlight with integrated motion and light sensor.
2. دستورالعمل های ایمنی
- ایمنی برق: Installation must be performed by a qualified electrician in accordance with all local and national electrical codes. Ensure the power supply is disconnected before installation, maintenance, or repair.
- جلدtage: بررسی کنید که حجم عرضهtage matches the requirements specified on the product label (220-240V AC, 50/60Hz).
- زمین کردن: The floodlight must be properly grounded to prevent electric shock.
- رتبه IP65: This product is rated IP65, meaning it is protected against dust ingress and low-pressure water jets from any direction. It is suitable for outdoor use but should not be submerged in water.
- دما: Do not operate the floodlight outside its specified operating temperature range.
- گرما: The floodlight surface may become hot during operation. Avoid direct contact.
- منبع نور: Do not stare directly into the LED light source when it is illuminated, as this may cause eye damage.
3. محتویات بسته
Carefully unpack the box and ensure all components are present and undamaged. The package should contain:
- Ledvance LED Floodlight with integrated motion sensor and light sensor
- نصب و استقرار براکت
- پیچهای نصب و پریزهای دیواری (ممکن است بسته به منطقه متفاوت باشد)
- راهنمای دستورالعمل (این سند)
4. نصب و راه اندازی
4.1 محل نصب
Choose a suitable mounting location that provides the desired illumination area and allows for optimal sensor performance. The floodlight can be surface-mounted on a wall, floor, or ceiling. Consider the following:
- مطمئن شوید که سطح نصب به اندازه کافی محکم باشد تا وزن نورافکن را تحمل کند.
- Avoid mounting near heat sources or reflective surfaces that could interfere with the motion sensor.
- For optimal motion detection, mount the floodlight at a height of 1.8 to 2.5 meters.
۴.۳ مراحل نصب
- قطع برق: قبل از شروع، مطمئن شوید که منبع تغذیه اصلی به محل نصب از طریق کلید قطع شده است.
- نقاط حفاری را علامت گذاری کنید: Use the mounting bracket as a template to mark the drilling points on the chosen surface.
- سوراخ های مته: Drill holes of appropriate size for the wall plugs. Insert the wall plugs.
- براکت را وصل کنید: با استفاده از پیچهای ارائه شده، براکت نصب را به سطح مورد نظر محکم کنید.
- اتصال برق: Connect the mains power cable to the floodlight's terminal block. Ensure correct polarity (Live, Neutral, Earth). Use a suitable waterproof junction box if necessary to maintain the IP65 rating.
- نورافکن را وصل کنید: Secure the floodlight body to the mounting bracket. Adjust the angle of the floodlight and the sensor as desired.
- بازیابی برق: پس از اتمام نصب و محکم بودن تمام اتصالات، برق را به مدار وصل کنید.
Image 2: Product dimensions (201mm x 56.5mm x 219mm).
5. عملیات
The Ledvance LED Floodlight operates automatically using its integrated motion and light sensors. There is no manual on/off switch for daily operation. The floodlight will activate based on the sensor settings.
۳.۲ تنظیم حسگر
The motion and light sensors can be adjusted to suit your specific needs. Typically, adjustment dials or buttons are located on the sensor unit itself. Refer to the markings on the sensor for specific functions.
- TIME (Delay Time): This dial controls how long the light remains on after motion is detected and no further motion is sensed. Common settings range from a few seconds to several minutes.
- لوکس (حساسیت به نور): This dial determines the ambient light level at which the sensor becomes active. Set it to a low LUX value for the light to activate only in dark conditions, or a higher LUX value for activation even in twilight.
- SENS (حساسیت/محدوده تشخیص): This dial adjusts the sensitivity of the motion sensor, controlling the detection range. A higher sensitivity setting will detect motion over a wider area or at a greater distance.
Adjust these settings carefully to prevent false triggers or insufficient illumination. Test the settings after each adjustment.
6. تعمیر و نگهداری
- تمیز کردن: قبل از تمیز کردن، برق را قطع کنید. از یک برس نرم و قابل انعطاف استفاده کنید.amp cloth to wipe the floodlight's surface. Do not use abrasive cleaners or solvents, as they may damage the finish or seals.
- بازرسی: Periodically inspect the floodlight and its wiring for any signs of damage, wear, or loose connections. Ensure the mounting remains secure.
- ناحیه حسگر: Keep the sensor lens clean and free from obstructions (e.g., dirt, leaves, spiderwebs) to ensure optimal performance.
- منبع نور LED: The LED light source is not user-replaceable. If the LEDs fail, the entire fixture should be replaced by a qualified professional.
7 عیب یابی
| مشکل | علت احتمالی | راه حل |
|---|---|---|
| چراغ روشن نمی شود | No power supply. Incorrect wiring. LUX setting too high (daylight). Sensor obstructed. | Check power supply and circuit breaker. Verify wiring connections. Adjust LUX setting. Clear any obstructions from the sensor. |
| نور به طور مداوم روشن می ماند. | Continuous motion detected. TIME setting too long. LUX setting too low (always dark). Wiring fault. | Check for constant motion in the detection zone. Adjust TIME setting. Adjust LUX setting. Inspect wiring for shorts. |
| Light turns on and off frequently. | Intermittent motion. Sensor sensitivity too high. Interference from heat sources or reflections. | Adjust SENS setting. Relocate the floodlight if possible. Remove interfering objects. |
| حسگر حرکت تشخیص نمیدهد. | Sensor obstructed. SENS setting too low. Incorrect mounting height/angle. | Clear obstructions. Adjust SENS setting. Re-evaluate mounting position and angle. |
If the problem persists after attempting these solutions, contact a qualified electrician or Ledvance customer support.
8. مشخصات فنی
Image 3: Product packaging displaying key technical specifications.
| مشخصات | ارزش |
|---|---|
| نام تجاری | LEDVANCE |
| شماره مدل مورد | 4099854306884 |
| ابعاد محصول | 20.1 × 5.7 × 21.9 سانتی متر |
| مواد | آلومینیوم |
| رنگ | سفید |
| سبک | مدرن |
| پایان | سفید |
| اجزای شامل | سنسور حرکت، سنسور نور |
| استفاده خاص | Path, Outdoor |
| Lampمواد سایه | آلومینیوم |
| جهت نور | LED |
| تغییر سبک | سنسور حرکت |
| نوع نصب | Surface Mounted (Floor or Ceiling Mounting) |
| باتری ها گنجانده شده است؟ | خیر |
| Lamp تایپ کنید | LED |
| برچسب انرژی اتحادیه اروپا | 146 لیتر بر وات |
| شار نورانی | 6000 لومن |
| واتtage | 41 وات |
| رتبه بندی IP | IP65 |
| رتبه IK | IK07 |
| دمای رنگ | 4000K (سفید سرد) |
9. گارانتی و پشتیبانی
This Ledvance LED Floodlight comes with a گارانتی 5 ساله, as indicated on the product packaging. This warranty covers defects in materials and workmanship under normal use and service conditions.
For warranty claims, technical support, or further assistance, please contact Ledvance customer service through their official website or the retailer from whom you purchased the product. Please have your proof of purchase and the product model number (4099854306884) available when contacting support.
For more information, visit the official Ledvance webسایت: www.ledvance.com
