مقدمه
This manual provides essential information for the proper installation, operation, and maintenance of your DD Audio 812F-D1 12-inch Dual 1-Ohm 7500W Subwoofer. Please read these instructions thoroughly before attempting to install or operate the subwoofer to ensure optimal performance and longevity.
ویژگی های کلیدی
- مدیریت حرارتی پیشرفته: Features a vented aluminum voice coil insert and finned aluminum heatsink designed to efficiently dissipate heat from critical components, ensuring sustained high-performance operation.
- Enhanced Excursion Capability: Equipped with a taller surround, double-stitched to a fiberglass-loaded, non-pressed cone, and a voice coil with increased winding length, supported by a double-layer spider for greater Xmax.
- ساخت و ساز قوی: Engineered for durability and high power handling, converting raw power into clean audio output.
- طراحی زیبایی شناسی: The heatsink features polished aluminum DD logos, and the motor is encased in an embossed rubber boot.
مشخصات
تصویر 1: جلو view of the DD Audio 812F-D1 subwoofer, showcasing مخروط و محیط اطراف آن.
| مشخصات | ارزش |
|---|---|
| اندازه بلندگو | 12 اینچ |
| وات RMS | 2500 وات |
| واتس پیک | 7500 وات |
| امپدانس | دو اهم (D1) |
| قطر سیمپیچ صوتی (VCD) | 4 اینچ |
| قطر پیستون | 10.25 اینچ |
| فرکانس رزونانس (FS) | 34 هرتز |
| Qms (ضریب Q مکانیکی) | 6.282 |
| Qes (ضریب Q الکتریکی) | 0.601 |
| Qts (فاکتور Q کل) | 0.548 |
| واس (حجم معادل) | 18.84 لیتر |
| Xmech (Mechanical Excursion) | 100 میلی متر |
| Xmax (گشت خطی) | 31 میلی متر |
| Frame OD (Outer Diameter) | 12.625 اینچ |
| Frame OD w/Gasket | 12.875 اینچ |
| قطر نصب | 11.34 اینچ |
| عمق نصب | 11 اینچ |
| قطر موتور | 9.45 اینچ |
| عمق موتور | 5.8 اینچ |
| حجم محفظه پورت شده توصیه شده | ۱.۷۵ تا ۲.۷۵ فوت مکعب |
| وزن مورد | 80 پوند |
| مواد | آلومینیوم |
راه اندازی و نصب
Proper installation is crucial for the performance and longevity of your subwoofer. If you are unsure about any steps, it is recommended to seek assistance from a professional installer.
1. Enclosure Selection and Construction
The DD Audio 812F-D1 is designed for optimal performance in a ported enclosure. Refer to the specifications section for recommended enclosure volumes (1.75 - 3.0 CuFt). Ensure the enclosure is robust, sealed properly, and adequately braced to prevent rattles and resonance. The mounting diameter required is 11.34 inches and mounting depth is 11 inches.
تصویر ۳: زاویهدار view of the DD Audio 812F-D1 subwoofer, highlighting the robust motor structure.
2. Wiring and Impedance
This subwoofer features a Dual 1-Ohm voice coil configuration. It is critical to wire the voice coils correctly to achieve the desired impedance load for your amplifier. Common wiring configurations include:
- سیمکشی موازی (۱ اهم): Connect positive to positive and negative to negative terminals of both voice coils. This results in a 0.5 Ohm load, which requires an amplifier stable at this impedance.
- Series Wiring (2 Ohm): Connect the positive of one voice coil to the negative of the other. The remaining positive and negative terminals are then connected to the amplifier. This results in a 2 Ohm load.
همیشه خود را تضمین کنید amplifier is stable at the chosen impedance. Using an amplifier with an impedance lower than its stable rating can cause damage to both the ampلیفایر و ساب ووفر
3. Ampتطبیق دهنده
Match the subwoofer's RMS power handling (2500W) with an amplifier that can provide sufficient clean power at the selected impedance. Underpowering a subwoofer can be as damaging as overpowering it, as it can lead to amplifier clipping and distorted signals.
4. نصب ایمن
Mount the subwoofer securely within the enclosure using appropriate fasteners. Ensure there is no air leakage around the mounting flange.
دستورالعمل های عملیاتی
Follow these guidelines for safe and optimal operation of your subwoofer.
- دوره شکست: Allow a break-in period of approximately 20-30 hours of moderate listening before operating the subwoofer at high volumes. This allows the suspension components to loosen and perform optimally.
- تنظیم سود: را تنظیم کنید ampبهره تقویتکننده به درستی با ولتاژ خروجی مطابقت داشته باشدtage of your head unit. Incorrect gain settings can lead to clipping and damage. Use a digital multimeter or oscilloscope for precise gain setting.
- تنظیمات متقاطع: Utilize a low-pass filter (LPF) on your amplifier or head unit to send only low frequencies to the subwoofer. A typical starting point for LPF is 60-80 Hz.
- فیلتر سابسونیک: Use a subsonic filter (high-pass filter for the subwoofer) to protect the subwoofer from playing frequencies below its tuning frequency, which can cause excessive excursion and damage.
- به اعوجاج گوش دهید: If you hear any distortion, rattling, or unusual noises, immediately reduce the volume. Continuous operation with distortion can cause permanent damage.
Image 3: Rear angled view of the DD Audio 812F-D1 subwoofer, showing the motor and terminal connections.
تعمیر و نگهداری
The DD Audio 812F-D1 subwoofer requires minimal maintenance to ensure long-term performance.
- بازرسی منظم: Periodically inspect the subwoofer cone, surround, and dust cap for any signs of damage, tears, or punctures.
- پاکیزگی: Keep the subwoofer free from dust and debris. Use a soft, dry cloth to gently wipe surfaces. Avoid using harsh chemicals or excessive moisture.
- بررسی اتصال: Ensure all wiring connections remain secure and free from corrosion. Loose connections can lead to signal loss or damage.
- حفاظت از محیط زیست: ساب ووفر را از دمای شدید، نور مستقیم خورشید و رطوبت محافظت کنید، زیرا این عوامل میتوانند به مرور زمان باعث تخریب مواد شوند.
عیب یابی
If you experience issues with your subwoofer, consult the following common troubleshooting steps.
- بدون صدا:
- تمام اتصالات برق و زمین را بررسی کنید ampزنده تر
- Verify RCA signal cables are securely connected from the head unit to the ampزنده تر
- اطمینان حاصل کنید amplifier is powered on (check power indicator light).
- Confirm the subwoofer wires are correctly connected to the amplifier and the subwoofer terminals.
- بررسی کنید ampفیوزهای تقویت کننده
- صدای مخدوش:
- را کاهش دهید ampتنظیم بهره تقویتکننده.
- Check for proper crossover settings; ensure the subwoofer is not playing frequencies too high.
- Inspect the subwoofer cone and surround for physical damage.
- اطمینان حاصل کنید amplifier is not clipping (indicated by a clipping light on some ampزندانیان آزاد)
- صدای بیس ضعیف:
- تأیید کنید amplifier gain is set appropriately.
- Check phase settings on the ampفایر یا یونیت سر
- Ensure the enclosure is sealed and properly constructed.
- Confirm correct wiring impedance for the ampزنده تر
- Subwoofer Overheating:
- Reduce volume and allow the subwoofer to cool.
- تأیید کنید amplifier is matched correctly to the subwoofer's RMS power handling.
- از تهویه کافی در اطراف اطمینان حاصل کنید ampلایفایر و ساب ووفر
- Check for proper impedance matching.
تصویر ۵: پایین view of the DD Audio 812F-D1 subwoofer motor, showing the heatsink design.
اطلاعات گارانتی
The DD Audio 812F-D1 Subwoofer comes with a گارانتی محدود. Specific terms and conditions of the warranty are typically provided with the product packaging or can be obtained from the manufacturer's official webلطفاً رسید خرید خود را برای هرگونه ادعای گارانتی نگه دارید.
This warranty generally covers defects in materials and workmanship under normal use. It typically does not cover damage resulting from improper installation, abuse, accident, neglect, unauthorized repair, or modifications.
پشتیبانی کنید
For further assistance, technical support, or warranty inquiries, please contact DD Audio customer support or the authorized retailer from whom you purchased the product. Refer to the official DD Audio webسایت برای اطلاعات تماس و منابع اضافی.
Note: Always ensure to provide your product model (812F-D1) and proof of purchase when contacting support.
