Sharp Home LED Digital Alarm Clock User Manual

1. مقدمه

Thank you for choosing the Sharp Home LED Digital Alarm Clock. This clock is designed for simplicity and ease of use, featuring a large red LED display, a convenient swivel base, and essential functions like alarm, snooze, and brightness control. This manual provides instructions for setup, operation, and maintenance to ensure optimal performance of your device.

2. اطلاعات ایمنی

• Read all instructions before operating the clock.
• دستگاه را در معرض دمای شدید ، نور مستقیم خورشید ، گرد و غبار یا رطوبت قرار ندهید.
• Use only the specified power source (AC 120V outlet). Do not use with 240V.
• دستگاه را از آب یا مایعات دیگر دور نگه دارید.
• سعی در جداسازی قطعات یا تغییر دستگاه نکنید. تمام مراحل سرویس را به پرسنل واجد شرایط ارجاع دهید.
• از تهویه مناسب اطراف دستگاه اطمینان حاصل کنید.

3. راه اندازی

3.1 اتصال برق

To power the clock, plug the power cord into a standard US 120V electrical outlet. The clock will immediately display the time.

۵.۲ نصب باتری پشتیبان

For backup power during an outage, insert one 9V battery (not included) into the battery compartment located on the bottom of the clock. During battery backup, the display will go blank, but time and alarm settings will be retained, and the alarm will still sound at the set time.

جلو view of the Sharp Home LED Digital Alarm Clock, displaying red LED digits on a gun metal grey case with a swivel base.

4. دستورالعمل های عملیاتی

4.1 تنظیم زمان

1. Locate the 'TIME SET' button on the back or bottom of the clock.
2. Press and hold the 'TIME SET' button. The hour digits will begin to flash.
3. Use the 'HOUR' and 'MINUTE' buttons to adjust the time. Observe the 'PM' indicator for correct AM/PM setting.
4. Release the 'TIME SET' button to save the time.

4.2 تنظیم زنگ هشدار

1. Locate the 'ALARM SET' button.
2. Press and hold the 'ALARM SET' button. The alarm hour digits will flash.
3. Use the 'HOUR' and 'MINUTE' buttons to set your desired alarm time.
4. Release the 'ALARM SET' button to save the alarm time. The 'ALM' indicator on the display will light up, indicating the alarm is active.

4.3 Alarm Volume Control

The alarm features a high/low volume setting. Refer to the controls on the back or side of the clock to adjust the alarm volume to your preference.

4.4 عملکرد تعویق

When the alarm sounds, press the 'SNOOZE' button (usually a large button on top) to temporarily silence the alarm for approximately 9 minutes. You can press the snooze button repeatedly until the alarm is manually switched off.

4.5 Display Brightness Dimmer

The clock features a high/low brightness option for the LED display. Locate the 'DIMMER' or 'BRIGHTNESS' switch/button on the unit to adjust the display intensity to your comfort level, especially for nighttime viewing.

4.6 Swivel Base

The clock is equipped with a 90-degree swivel base, allowing you to adjust the viewing angle for optimal visibility from various positions in your room.

An infographic highlighting the clock's features: 1.8-inch red LED display, high/low alarm volume control, high/low display dimmer control, 90-degree swivel case, and optional 9V battery backup.

The Sharp LED Digital Alarm Clock shown rotating on its 90-degree swivel base, illustrating its adjustable viewزاویه

A diagram indicating the dimensions of the Sharp LED Digital Alarm Clock: 6.25 inches wide, 4 inches high, and 2.15 inches deep.

5. تعمیر و نگهداری

• تمیز کردن: ساعت را با یک پارچه نرم و خشک پاک کنید. از پاک کننده ها یا حلال های ساینده استفاده نکنید.
• تعویض باتری: Replace the 9V backup battery annually or as needed to ensure continuous backup functionality.
• ذخیره سازی: If storing the clock for an extended period, remove the backup battery to prevent leakage.

6 عیب یابی

• No Display/Clock Not Working:
  Ensure the power cord is securely plugged into a working 120V outlet. Check if the outlet is receiving power. If using battery backup, remember the display goes blank during power outages, but internal functions are maintained.
• زنگ هشدار به صدا در نمی آید:
  Verify that the alarm time is set correctly and the 'ALM' indicator is lit on the display. Check the alarm volume setting.
• صفحه نمایش خیلی روشن/کم‌نور:
  Adjust the brightness using the 'DIMMER' or 'BRIGHTNESS' control.
• Time Not Keeping Correctly:
  Ensure the clock is connected to a stable power source. If frequent power interruptions occur, ensure the backup battery is fresh.

7. مشخصات

8. گارانتی و پشتیبانی

For warranty information or technical support, please refer to the documentation included with your purchase or visit the official Sharp webرسید خرید خود را به عنوان مدرک خرید برای هرگونه ادعای گارانتی نگه دارید.