Audio-Technica AT-LP60XBT-WH Fully Automatic Bluetooth Belt-Drive Stereo Turntable

مقدمه

The Audio-Technica AT-LP60XBT-WH is a fully automatic belt-drive stereo turntable designed for both wired and wireless audio playback. It features Bluetooth wireless technology for connecting to compatible speakers, headphones, or other devices, including support for the aptX codec for enhanced sound quality. The turntable also offers traditional wired connectivity via its dual RCA output cable. Its automatic operation simplifies playback with front-panel controls for start, stop, and tonearm lift. The unit incorporates a dual magnet cartridge with a replaceable stylus and plays records at 33-1/3 and 45 RPM speeds.

This image displays the Audio-Technica AT-LP60XBT-WH turntable from an elevated angle. The unit is white and black, with a clear, hinged dust cover lifted open. The black platter, featuring the Audio-Technica logo, is visible, along with the tonearm and stylus. Control buttons for speed, start, and stop are located on the front panel.

محتویات بسته

مطمئن شوید که تمام موارد زیر در بسته شما موجود است:

• AT-LP60XBT-WH Turntable Unit
• Detachable RCA output cable (3.5 mm male to dual RCA male)
• آداپتور 45 دور در دقیقه
• پوشش گرد و غبار لولایی قابل جدا شدن

راه اندازی

1. قرار دادن: صفحه گردان را روی یک سطح صاف و پایدار و دور از نور مستقیم خورشید، منابع گرما و لرزش بیش از حد قرار دهید.
2. Install Platter and Belt:
   • Carefully place the aluminum platter onto the turntable spindle.
   • Locate the drive belt, which is usually pre-installed on the underside of the platter or included separately.
   • Align the belt with the motor pulley, which is typically a small brass or plastic cylinder located near the spindle. Use the red tab to pull the belt over the motor pulley. Ensure the belt is not twisted.
   • تشک نمدی را روی بشقاب قرار دهید.
3. Install Dust Cover: Insert the hinges of the dust cover into the hinge holders at the rear of the turntable unit.
4. اتصال به برق: Connect the AC adapter to the turntable's power input and then plug it into a wall outlet.
5. اتصال صوتی:
   • اتصال سیمی: Connect the included dual RCA output cable from the turntable's output jacks to the audio input of your amplifier, powered speakers, or stereo system. Ensure the PHONO/LINE switch on the rear of the turntable is set correctly (PHONO for phono input, LINE for line input).
   • اتصال بی‌سیم (بلوتوث): Proceed to the Bluetooth Connectivity section for pairing instructions.

دستورالعمل های عملیاتی

1. روشن کردن: Press the power button on the front panel to turn on the turntable. The Bluetooth indicator will illuminate.
2. انتخاب سرعت: Press the 'SPEED' button to select the appropriate playback speed for your record (33-1/3 RPM or 45 RPM).
3. رکورد مکان: یک صفحه گرامافون روی صفحه قرار دهید. اگر یک تک‌آهنگ ۴۵ دور در دقیقه پخش می‌کنید، از آداپتور ۴۵ دور در دقیقه که همراه دستگاه ارائه شده است استفاده کنید.
4. شروع پخش: Press the 'START' button. The tonearm will automatically move to the beginning of the record and begin playback.
5. توقف پخش: Press the 'STOP' button. The tonearm will automatically lift, return to its rest, and the platter will stop spinning.
6. Manual Tonearm Lift: Use the 'TONEARM LIFT' button to manually raise or lower the tonearm during playback if needed.

قابلیت اتصال بلوتوث

The AT-LP60XBT-WH turntable can connect wirelessly to Bluetooth-enabled speakers, headphones, or other audio devices.

1. بلوتوث دستگاه خود را فعال کنید: Ensure your Bluetooth speaker or headphones are in pairing mode. Refer to your device's manual for specific instructions.
2. Initiate Turntable Pairing: With the turntable powered on, press and hold the Bluetooth button (usually indicated by a Bluetooth symbol) on the turntable's front panel for a few seconds until the Bluetooth indicator light begins to flash rapidly. This indicates the turntable is in pairing mode.
3. اتصال: Once the turntable and your Bluetooth device are successfully paired, the Bluetooth indicator light on the turntable will change from rapidly flashing to a steady blue light.
4. aptX Codec: This turntable supports the aptX codec, which provides higher quality audio streaming over Bluetooth with compatible devices.

تعمیر و نگهداری

• پوشش گرد و غبار: Keep the dust cover closed when not in use to protect the turntable from dust and debris. Clean the dust cover with a soft, dry cloth. Avoid using harsh chemicals.
• مراقبت از قلم: Gently clean the stylus regularly using a soft brush designed for stylus cleaning, brushing from back to front. A dirty stylus can degrade sound quality and damage records.
• جایگزینی قلم: The stylus is replaceable. Refer to the Audio-Technica website or your local dealer for compatible replacement styli.
• بدنه صفحه گردان: Wipe the turntable body with a soft, dry cloth. Do not use solvents or abrasive cleaners.

عیب یابی

مشخصات

گارانتی و پشتیبانی

For detailed warranty information, product registration, and customer support, please refer to the documentation included with your Audio-Technica AT-LP60XBT-WH turntable or visit the official Audio-Technica website. Contact information for technical assistance and service may also be found there.