مقدمه
This instruction manual provides essential information for the proper installation, operation, and maintenance of your Audio-Technica VMN30EN Elliptical Nude Replacement Turntable Stylus. Please read this manual thoroughly before use to ensure optimal performance and longevity of your stylus. The VMN30EN is specifically designed for compatibility with Audio-Technica VM530EN cartridges.

Image 1: The Audio-Technica VMN30EN Elliptical Nude Replacement Turntable Stylus. This image displays the stylus unit, which is orange with a clear protective cover, designed for precise audio reproduction from vinyl records.
ویژگی های محصول
- شکل قلم: Elliptical (0.3 x 0.7 mil) for accurate tracking and detailed sound reproduction.
- ساخت قلم: Nude Round Shank, indicating a high-quality, precision-mounted diamond tip directly on the cantilever.
- سازگاری: Designed as a direct replacement stylus for Audio-Technica VM530EN cartridges.

تصویر ۱.۲: بزرگنمایی شده view illustrating the elliptical stylus shape and nude round shank construction of the VMN30EN. This design contributes to precise groove tracing and reduced distortion.
راه اندازی و نصب
Replacing your turntable stylus requires careful handling. Always ensure your turntable is powered off and the tonearm is secured before beginning.
- آماده سازی: Gently remove the old stylus by holding the cartridge body and pulling the stylus unit downwards and forwards.
- نصب و راه اندازی: Hold the new VMN30EN stylus unit by its plastic housing. Align the new stylus with the cartridge body and push it gently upwards and backwards until it clicks securely into place. Do not force it.
- تایید: Ensure the stylus is firmly seated and properly aligned.
- نیروی ردیابی: After replacing the stylus, it is recommended to re-check and adjust your turntable's tracking force and anti-skate settings according to your cartridge's specifications for optimal performance and to prevent record wear. Refer to your turntable's manual for specific instructions on adjusting these settings.

تصویر ۴: یک نمای عقب view of the VMN30EN stylus, showing the connection points that integrate with the cartridge body. This perspective is useful for understanding the installation mechanism.
دستورالعمل های عملیاتی
Once the VMN30EN stylus is correctly installed and tracking force is set, you can begin playing records.
- Always lower the tonearm gently onto the record using the cueing lever to prevent damage to the stylus or record.
- Avoid dropping the tonearm onto the record.
- Ensure records are clean and free of dust before playback to minimize wear on the stylus and improve sound quality.
تعمیر و نگهداری
Regular maintenance will extend the life of your stylus and preserve sound quality.
- تمیز کردن قلم: Gently brush the stylus tip from back to front using a soft stylus cleaning brush. Do not brush from side to side or front to back, as this can damage the cantilever. Use a specialized stylus cleaning fluid sparingly if necessary.
- پوشش گرد و غبار: Keep your turntable's dust cover closed when not in use to protect the stylus from dust and debris.
- جایگزینی: Stylus tips wear out over time. Replace your stylus after approximately 300-500 hours of use, or sooner if you notice a degradation in sound quality or increased record wear.
عیب یابی
اگر با مشکلاتی مواجه شدید، راهحلهای رایج زیر را در نظر بگیرید:
- کیفیت پایین صدا / اعوجاج:
- Check if the stylus is clean and free of debris.
- Verify that the stylus is correctly seated in the cartridge.
- Re-check tracking force and anti-skate settings.
- Ensure the record is clean.
- Consider if the stylus needs replacement due to wear.
- پرش:
- Ensure the record is flat and clean.
- Verify tracking force is set correctly.
- Check anti-skate settings.
- Inspect the stylus tip for damage.
- صدا قطع یا قطع میشود:
- Confirm all audio cables are securely connected.
- Ensure the turntable is powered on and connected to an appropriate phono input.
- Check if the stylus is properly installed.
مشخصات
| ویژگی | جزئیات |
|---|---|
| شماره مدل | VMN30EN |
| شکل قلم | Elliptical (0.3 x 0.7 mil) |
| ساخت قلم | Nude Round Shank |
| سازگاری | Audio-Technica VM530EN Cartridges |
| ابعاد محصول | 4 x 1 x 3 اینچ |
| وزن مورد | 1.16 اونس |
| سازنده | صوتی-تکنیکی |
| تاریخ برای اولین بار در دسترس است | 31 اکتبر 2016 |
گارانتی و پشتیبانی
For detailed warranty information, please refer to the warranty card included with your original product packaging or visit the official Audio-Technica webسایت
For further technical support or inquiries, please contact Audio-Technica customer service through their official channels.





