Everycom Projector
Important Safeguards
- Please read the manual carefully before operating projector. To ensure stable power supply, please use standard power cord.
- Please use the power supply and cable indicated on the rating label. The projector should be kept away from cloths, sofas and anything that may block the ventilation scoop. Please keep the unit away from flammable and explosive materials.
- Please do not disassemble the unit yourself as this will invalidate the warranty service. To protect your eyes,do not stare directly at the lens when the projector is on. The projector must be kept away from water and any other liquids.
- To prevent electric shock, please keep the projector out of the rain and away from moisture. It is recommended to switch off the projector after it has run for 6 hours non-stop. Please use the original foam and other cushioning materials when transporting the projector.
- If the projector does not work, please contact the authorized service agent.
Structural Diagram
- VGA for laptop or computer input
- IR for remote control
- Headphone port for audio outpul
- AV port for normal signal input
- USB port for multimedia play
- OUT 5V
- HDMI port for HD signal input
PaneI Functions
- Source: choose the input signal source
- Menu: operate multiple functions
- Return
- Signal lights
- Up: move up
- Power Button: power on or off
- Left: move left or volume down
- Down: move down
- Right: move right or volume up
Function Operation
- Power
- Aspect ratio
- Arrow keys
- Homepage
- Menu
- Volume Down
- Setting
- Screen flip
- Source
- Enter
- Exit
- Volume Up
- Mute
Focus/Keystone
- Focus
- Keystone
Miracast Connection
DLNA
Bluetooth Setup
If you want to connect a Bluetooth device, you can go to setup—Bluetooth—Scan to select your Bluetooth device, and confirm the connection.
*You have to set your Bluetooth device in pair mode firstly before scan. 
Digital Zoom
You can change the picture size by adjusting Digital Zoom.
*Digital Zoom can be adjusted only while using HDMI\VGA\AV\Media, not iOS cast\Miracast.
Documents / Resources
 | Projector |
References
- User Manualmanual.tools
Published: May 24, 2021
meu projetor não entra nas configurações eu cliquei em cima mais não entra não abre o menu de configuração
como faço para fazer o reset nele
como faço para fazer o reset nele
How do I access the settings menu and perform a factory reset on my Everycom projector if the menu button is not responding?
If you are unable to open the settings menu using the projector's physical buttons or the remote, please try the following steps based on the Everycom instruction manual:
If the menu still does not open after a power cycle, there may be a hardware fault with the control board or the remote receiver, and you should contact an authorized service agent as suggested in the manual's safeguards.
Note: The provided manual image mentions 'Artlii' in the Bluetooth settings, suggesting this firmware is shared across several budget projector brands including Everycom.
Read the full Q&A page