evertoco Premium Adjustable Flagpole Kit

Features
- Built-in upgraded hard glass beads, lifetime rust-proof
- High-strength rust-proof aluminum, for flag attachment
- Stainless steel top ornament
- Rust-proof carabiners that fit bracket mounting holes
Premium Adjustable Flagpole Kit – 1″ Diameter, 1.3′ to 6′ Height
Parts List

Before Use
- Tool Preparation
- Drill with matching drill bits (for wall/ground mounting)
- Tape measure, level
- Rubber mallet (for bracket position adjustment)
- Surface Check
- Ensure mounting surface is flat, dry, and free of cracks/looseness.
- Pre-drill holes for wooden surfaces; use expansion screws (not included) for concrete/brick walls .
- Component Inspection
- Verify all flagpole sections are intact; check anti-tangle rings rotate smoothly .
- Confirm carabiners and wing screws are rust-free (all parts feature rust-proof construction) .
Attach
- Step 1: Mount the Bracket
- Mark drill positions on the surface using the bracket as a template.
- Drill holes and insert wall anchors (if needed); secure the bracket with wing screws, tightening by hand .
- Use a level to confirm the bracket is straight; adjust angle to 90° or 45° per 需求.
- Step 2: Assemble the Flagpole
- Connect the 5 flagpole sections: Insert each section into the next until fully engaged.
- Adjust total length to 2’/3’/4’/5’/6′ by adding/removing sections .
- Attach anti-tangle rings to the pole (1 near top, 1 midway) – ensure glass bead mechanism rotates freely.
- Step 3: Install Flag & Finial
- Screw the finial ball onto the top of the fully assembled pole.
- Attach flag grommets to 4 carabiners; clip carabiners to the anti-tangle rings .
- Insert the flagpole base into the mounted bracket; secure with wing screws.
- Step 4: Final Check
- Gently pull the flag to confirm carabiners and rings hold securely.
- Verify the pole is stable at the selected angle (90°/45°) .
Key Features & Usage Tips
- Load Capacity: Designed to withstand local wind, rain, and snow with all-rust-proof components .
- Anti-Tangle Design: 4 carabiners + rotating glass-bead rings prevent flag wrapping in wind .
- Height Adjustment: Modify length by adding/removing sections (1.3′ minimum when using 2 sections).
Remove & Disassemble
- Loosen wing screws on the bracket; lift out the flagpole.
- Disconnect sections by twisting and pulling gently (avoid force to prevent damage).
- Remove the bracket by unscrewing wing screws; patch drill holes if needed .
Use and Care Manual
- Daily Use
- Inspect wing screws monthly and retighten if loose (critical for stability in high winds) .
- Do not exceed the pole’s structural capacity (designed for standard-sized flags).
- Cleaning
- Wipe flagpole and bracket with a soft cloth; rinse with fresh water if exposed to salt spray, dry thoroughly .
- Do not use abrasive cleaners (may damage rust-proof coating).
- Storage
- Disassemble into 5 sections; store in a dry place.
- Keep carabiners and rings separated to avoid scratching .
Frequently Asked Questions
Q: Can the flagpole be left outside in all weather conditions?
A: The flagpole is designed to withstand local wind, rain, and snow with its rust-proof components. However, for prolonged durability, it is recommended to take down the flag during severe weather conditions.
Q: How do I adjust the height of the flagpole?
A: You can modify the length of the flagpole by adding or removing sections. The minimum height when using two sections is 1.3 feet.
Documents / Resources
![]() | Premium Adjustable Flagpole Kit |
References
- User Manualmanual.tools
Published: November 24, 2025

