ESCAPE Hangboard Mount Instruction Manual

ESCAPE Hangboard Mount

Product Specifications

• Product Name: Hangboard Mount
• Material: Wood and Metal
• Dimensions: 24″ x 12″ x 6″
• Weight: 5 lbs

Assembly Instructions

HANGBOARD MOUNT

STEP 1:
Tap the frame sides into the t-nut attachment bar with a non marking mallet.

HAMMER HARD!
It may take some effort to fit all components together.

STEP 2:
Now hammer the frame sides onto the large wall mount with the non marking mallet.

STEP 3:
Tap the engraved board onto the frame sides with a mallet

STEP 4:
3) Be sure the mount assembly is snuggly tapped together.
Drill into the front guide holes with a 1/8 drill bit, Fasten through the guide holes with short T25 screws. Take care to not over drive the screws. The head of each screw should sit flush with the wood surfaces. Repeat for the back.

STEP 5:
Attach to vertical wall using all available screw holes.

COMPLETE!
Have any more questions? Contact us at orders@escapeclimbing.com or watch the installation video below!

https://youtu.be/GgPEHMmrig0?si=r5x24B_xDBXUBHu_

Frequently Asked Questions

Q: How do I contact for further assistance?
A: For any additional questions or assistance, please contact us at orders@escapeclimbing.com

Q: Is there an installation video available?
A: Yes, you can watch the installation video at the following link: InstallationVideo

Q: What if I encounter difficulties during assembly?
A: If you encounter any difficulties during assembly, please refer to the provided instructions carefully or contact our support team for assistance.

ESCAPECLIMBING.COM