ERM Advanced Telematics IoTLink Shadow Wireless Multi-Functional IoT Tracker Transmitter
More Info
Email: info@ermtelematics.com
Tel: +972-3-9413313
Fax: +972-3-9413316
ERM Electronic Systems LTD
16 Hasar Shapira St. Rishon Lezion, Israel
www.ermtelematics.com
Introduction
- IoTLink Shadow is a compact, battery-powered tracker and cellular gateway for IoT Monitoring and Asset Tracking applications.
- IoTLink Shadow offers immediate and wireless implementation in any of the applications without the need for wiring or external power source of any kind.
- IoTLink Shadow has a very low power consumption and a special power management technology which makes it a great solution for visible or concealed tracking, monitoring and as an IoT gateway to various sensors.
- IoTLink Shadow comes with many unique features supporting various IoT, UBI, SVR and Tracking applications
- IoTLink Shadow can come in a regular or
variant which will include external power connector..
FEATURES
- No installation required
- Standard Short-Range communication for sensors and mobile devices
- Accident detection
- Parking Habits monitoring
- Trips count – Trip Start / End
- Manual Tracking mode
- Remote configuration and management (FOTA)
- Command-controlled transmission profiling for power endurance
- Dedicated Messages Server for delayed commands
- Replaceable / Rechargeable battery (optional)
- Smart Input for Gas Levelling system (optional)
- Multiple transmission modes – Asset / Tracking / Idle (optional – variant inc. external power) / Auto Tracking / Manual / Moving – Stop
Modes
TECHNICAL SPECIFICATIONS
|
Cellular |
4G LTE CATm-1 / NB-IoT with optimized embedded antenna. |
|
Location |
GPS/GLONASS/GALILEO , Active antenna, Sensitivity -165 dB, NMEA, Acquisition (normal): cold <34s, warm <30s, hot <1s, accuracy: 2.5m CEP Embedded optimized antenna |
|
Communication |
Text messages, TCP/IP over GPRS/UMTS/EDGE/HSPA,
Standard short range communication module v4.0, 2.4Ghz (in iRF Variant) |
| Power Supply | Internal replaceable battery 3.6VDC, 4,400mA |
| Configuration /
Firmware Update |
OTA, parameters setup, software programming |
| Data Logger | Up to 1,000 messages |
ENVIRONMENT
| Operating Temperature | -20 to 70° C |
| Storage Temperature | -40 to 85° C |
| Dimensions | 9.39cm x 4.5cm x 2.74cm |
| Weight (NET) | 100gr |
| Max. Relative Humidity | 90(±5)% |
FCC warning statements
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Caution: Any changes or modifications to this device not explicitly approved by the manufacturer could void your authority to operate this equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
The device has been evaluated to meet the general RF exposure requirements This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment.
This equipment should be installed and operated with a minimum distance 20cm between the radiator & your body.
Frequently Asked Questions
Q: What is the difference between the regular and EP variant of IoTLink Shadow?
A: The EP variant includes an external power connector for additional power options.
Q: Can IoTLink Shadow support voice communication with drivers?
A: Yes, the VO variant supports voice communication using a Speaker and Microphone included in the kit. Additional features like keypad or push button for emergency dialing can be added.
Documents / Resources
 |
ERM Advanced Telematics IoTLink Shadow Wireless Multi-Functional IoT Tracker Transmitter [pdf] User Guide IoTLink Shadow Wireless Multi-Functional IoT Tracker Transmitter, IoTLink Shadow, Wireless Multi-Functional IoT Tracker Transmitter, Multi-Functional IoT Tracker Transmitter, IoT Tracker Transmitter, Transmitter |