ErgoHide Height Adjustable Frame Instruction Manual

ErgoHide Height Adjustable Frame

Product Information

Technical Specifications:

• Input: AC 100-240V, 50/60Hz
• Output power: 100W
• Load capacity: 100kg
• Max. speed: 20mm/s
• Stroke: 500mm
• Min. install dimension: 600mm x 600mm
• Operation temperature: 0°C to 40°C
• Duty cycle: 10%

Product Usage Instructions

Step 1: Assembling the Frame

1. Identify all components from the list provided in the user manual.
2. Start by attaching the rubber pads to the designated areas on the frame using the M5x16 screws.
3. Attach the lifting columns to the frame using the M6x16 screws.
4. Secure the control box and motor cables in their respective positions.
5. Use the cable clips to organize and secure the cables for a tidy setup.

Step 2: Adjusting the Height

1. Connect the power cable to the control box and plug it into a power source.
2. Use the handset to control the height adjustment of the frame. Press the appropriate buttons to raise or lower the frame as needed.
3. Ensure the frame is at the desired height before use.

FAQs

• Q: What should I do if the frame does not move when using the handset?
  • A: Check the connections of the motor cable and power cable. Ensure they are properly connected and try again.
• Q: Can I exceed the maximum load capacity of the frame?
  • A: It is not recommended to exceed the maximum load capacity as it may damage the motor and compromise safety.

PARTS AND TOOL

PRODUCT INSTALLATION

PRODUCT OVERVIEW

Notice

1. This product must be used under the correct technical parameters.
2. Keep away from liquids, corrosive gases, and dusty environment.
3. Contact us if necessary

Technical specifications

• Input:100~240 VAC
• Output power:24 VDC
• Load capacity:140 kg
• Max. speed:30 mm/s
• Stroke:650 mm
• Min. install dimension:600 mm
• Operation temperature:5-40 °C
• Duty cycle:2 min. on and 18 min. off