EPSON-logo

EPSON SD-880 Dual Floppy Disk Drive

EPSON-SD-880-Dual-Floppy-Disk-Drive-product

OVERVIEW

Doom Keeper GK-100DL

Features

  • Three-color backlight
  • Backlit symbols and keys
  • Metal base for increased durability

More Information: defender.ru

Werewolf GK-120DL

Features:

  • Metal base for increased durability
  • Hotkeys for quick access to office, multimedia, and internet applications
  • Rainbow backlight
  • More Information: defender.ru

Raid GK-778DL

Features:

  • Backlit symbols and keys
  • Rainbow backlight
  • Convenient flat keys

More Information: defender.ru

For a comprehensive list of Defender’s gaming keyboards, you can visit their official catalog: defender.ru If you have specific features in mind or need assistance with other models, feel free to ask!

Specifications

  • Model: EPSON SD-880
  • Compatibility: IBM PC-compatible computers
  • Interface: ISA
  • Drive Types: 3.5″ 1.44MB and 5.25″ 1.2MB

Installation Instructions

Step 1: Preparation
Turn off the computer and disconnect the power cable to avoid any electrical hazards.EPSON-SD-880-Dual-Floppy-Disk-Drive-fig-1

Step 2: Access FDD Slots
Refer to your computer manual to open the case and locate the FDD slots.EPSON-SD-880-Dual-Floppy-Disk-Drive-fig-2

Step 3: Mounting the FDD
Mount the EPSON SD-880 FDD in either the upper or lower slot using four screws, ensuring the bezel is flush with the front of the PC.EPSON-SD-880-Dual-Floppy-Disk-Drive-fig-3

Step 4: Jumper Configuration
Refer to the jumper settings to configure the FDD based on your requirements. Make changes with caution when the computer is off and unplugged.EPSON-SD-880-Dual-Floppy-Disk-Drive-fig-4

Step 5: Cable Connection

Attach the 4-pin power cable and the 34-pin edge connector to the rear of the FDD, aligning pin 1 to the left with the cable connector.

Jumper Configurations
Refer to the provided diagram for detailed jumper configurations for drive select and mode change settings.

FAQ

Q: How do I determine which drive (3.5″ or 5.25″) is set as Drive A or Drive B?
A: The jumper settings (SS1) determine which drive is assigned as Drive A or Drive B. In the default position (A), Drive A is set as the 3.5″ FDD if the dual drive is in the upper slot and uses the end FDD connector on the cable.

Documents / Resources

EPSON SD-880 Dual Floppy Disk Drive [pdf] Instructions
SD-800, SD-880 Dual Floppy Disk Drive, SD-880, Dual Floppy Disk Drive, Floppy Disk Drive, Disk Drive, Drive

References

Leave a comment

Your email address will not be published. Required fields are marked *