ENCELIUM SSU Vision Sensor Installation Guide

Q: Can the VISION Sensor be used with other lighting control systems?
- A: The VISION Sensor can be used with the Encelium X Lighting Control System with the addition of a DALI High-Bay Adapter.
Q: What is the range of the sensitivity adjustment settings?
- A: The sensitivity adjustment settings range from 5 to 13 meters based on the selected sensitivity level.

The VISION Sensor is a motion sensor ideal for large areas such as open-plan offices, corridors, and storage rooms.

The VISION Sensor can be used as a standalone solution or as part of the Encelium X Lighting Control System with the addition of a DALI High-Bay Adapter.
For more information on product specifications and design tools visit encelium.com.

READ THESE INSTRUCTIONS BEFORE USING THE PRODUCT

When using electrical equipment, basic safety precautions should always be followed, including the following:

Do not mount near gas or electric heaters or let power supply cords touch hot surfaces.
Equipment should be mounted in locations and at heights where it will not readily be subjected to tampering by unauthorized personnel.

The use of accessory equipment is not recommended by Encelium as it may cause an unsafe condition.
All DALI channels are internally connected to the control unit. Make sure to consider this when installing.

SAVE THESE INSTRUCTIONS.

With any Encelium wired design, you get a reliable, lighting control system that can be installed quickly and easily.

STEP 1 Remove the VISION Sensor cover by turning it counterclockwise. Place cover aside.
- Proceed to Step 2 if you are installing the VISION Sensor into the DALI High-Bay Adapter.
STEP 2 Remove the DALI High-Bay Adapter cover by turning it counterclockwise and lifting up.

STEP 3 CEILING INTEGRATION WITH DALI HIGH-BAY ADAPTER
- Cut a Ø 22 mm (0.87 inch) hole in the ceiling. Line up the DALI High-Bay Adapter holes to the ceiling hole and screw into the ceiling.
- Connect the Mains and DALI wires to the DALI High-Bay Adapter connector block. Connect the VISION Sensor wires to the DALI High-Bay Adapter connector block.
- Place the VISION Sensor into the DALI High-Bay Adapter and push until it clicks into place. Then install the VISION Sensor Cover by turning it clockwise until it is secure.

The DALI High-Bay Adapter features a SELECT Button, Sensitivity Adjustment, Light Sensor, and LED Indicator.

To confirm wiring connections quickly press the SELECT Button.
If DALI voltage is present the LED Indicator will turn on.
Another quick press of the SELECT Button will turn off the LED Indicator, otherwise, it will switch off after 30 seconds.
The Sensitivity Adjustment allows the lights to be set from bright to dark.
The Light Sensor can be adjusted in its sensitivity by a potentiometer to optimize measurement window usage (see the Light Sensitivity Range details below).

Light Sensitivity Range

VISION SENSOR FEATURES

The VISION Sensor features an LED Indicator, Motion Sensor, and Delay Button.
The Delay Button is used to set the delay between 10 seconds and 20 minutes (see the Delay Button Settings details below).

Delay Button Settings

FACTORY DEFAULT SETTINGS

To reset the DALI High-Bay Adapter to factory default settings, press and hold the SELECT button for approximately 10 seconds. The LED Indicator will blink for 4 seconds.
- Note: This does not reset the VISION Sensor to factory default settings.

SENSOR DETECTION RANGE

The detection range of the High-Bay Sensor must be set before it can detect motion.
Place objects that radiate heat outside the detection area and avoid drafts.