ENCELIUM SIM Low Voltage Sensor
Product Usage Instructions
- When using the SIM, adhere to the following safety precautions:
- The SIM interfaces sensors like occupancy and photosensors with the GreenBus communication network. Follow these steps for installation:
- Ensure installation in dry, indoor locations only.
- If installing in damp locations, use a damp-rated SIM.
- For some installations, a junction box may be required. Follow these steps for mounting:
- Securely mount the SIM to the junction box using an available PG-7 (0.5 inch) trade-size knockout and retainer nut.
- For wiring connections, follow these guidelines based on the type of sensor:
FAQ
- Q: Can I install the SIM in damp locations?
- A: The SIM is recommended for dry, indoor locations. For damp installations, use a damp-rated SIM.
- Q: What safety precautions should I follow when using the SIM?
- A: Avoid letting power cords touch hot surfaces, mounting near heat sources, and use only for the intended purpose.
PRODUCT SAFETY
- When using electrical equipment, basic safety precautions should always be followed, including the following:
READ THESE INSTRUCTIONS BEFORE USING THIS PRODUCT
- Do not let power supply cords touch hot surfaces.
- Do not mount near gas or electric heaters.
- Equipment should be mounted in locations and at heights where it will not readily be subjected to tampering by unauthorized personnel.
- The use of accessory equipment is not recommended by Encelium as it may cause an unsafe condition.
- Do not use this equipment for other than the intended use.
SAVE THESE INSTRUCTIONS
GETTING STARTED
Overview
The Sensor Interface Module (SIM) provides an interface between sensors such as occupancy and photosensors to the
GreenBus™ communication network. The SIM is automatically addressed as soon as it is connected to the Encelium
Wired Manager.
The SIM is available in two models:
- Indoor
- Damp Rated
WIRED SYSTEM OVERVIEW
- GreenBus technology makes wiring fast and error-free since it’s intuitive to install. With Encelium X, you can control DALI devices exclusively or a mixture of GreenBus and DALI.
INSTALLATION
- The SIM provides an interface between sensors such as occupancy and photosensors to the GreenBus communication network.
- Notes: The SIM is to be installed in dry, indoor locations ONLY. For damp installations, ensure to use the SIM (damp-rated).
- Damp locations are defined as: interior locations subject to moderate degrees of moisture, such as some basements, some barns, some cold-storage warehouses, and the like, and partially protected locations under canopies, marquees, roofed open porches, and the like.
MOUNTING OPTION
- Junction Box Mount For some installations, a junction box may be required. It is recommended to securely mount the SIM to the junction box using an available PG-7 (0.5 inch) trade-size knockout and retainer nut.
ELECTRICAL CONNECTIONS
- SIM to Low-Voltage Sensor or Wattstopper Wiring
- SIM to Photo Sensor Wiring
- SIM to Sensor Junction Box Wiring
- Contact Closure Wiring
- SIM Wiring
The module is made from tested material to be used in plenum or “plenum-rated” areas.
© Copyright 2024 Legrand All Rights Reserved.
© Copyright 2024 Legrand Alle Rechte vorbehalten
© Copyright 2024 Tous droits réservés Legrand.
© Copyright 2024 Legrand Todos los derechos reservados..
080428r1 01/24 encelium.com
Documents / Resources
 |
ENCELIUM SIM Low Voltage Sensor [pdf] Installation Guide SSU, SIM Low Voltage Sensor, SIM, Low Voltage Sensor, Sensor |