ELSYS ELT2 PT100 Module
Specifications
- Product Name: PT100 Module
- Compatibility: Fits inside ELT2
- Connection Type: 2-wire or 4-wire
- Usage: Connects PT100 platinum sensor
Installation
- Ensure power to ELT2 is switched off before installation.
- Open the ELT2 casing to access the internal components.
- Insert the PT100 module in the designated slot inside ELT2.
- Secure the module in place and close the casing.
Sensor Connection
The PT100 module is designed for connecting a PT100 platinum sensor. Follow these steps:
- Identify the sensor’s wire type (2-wire or 4-wire).
- Connect the sensor to the corresponding terminals on the PT100 module.
Frequently Asked Questions (FAQ)
Q: What is the purpose of the PT100 module?
A: The PT100 module is intended for connecting a PT100 platinum sensor to the ELT2 for temperature monitoring.
Technical manual PT100 module
Publish Date: 26.04.2024
Technical Manual
PT100 module
The PT100 module is a module that fits inside the ELT2 and is intended for connecting a PT100 platinum sensor with 2- or 4-wire connection.
Features
- Easy use with PT-100 (RTD platinum sensor)
- 2- or 4-wire connection
- Measures -200 to 790 °C
- Fits inside the ELT-2 box
- Powered by the ELT-2 internal battery
- Very low energy consumtion
- Terminal block for easy connection
Accuracy (RTD)
± 0.1 °C (-40 to 200°C) + sensor deviation. ± 0.5 °C (full span) + sensor deviation.
Using the PT100 module with a PT100 RTD
- Set external sensor in the ELT2 to “PT100”
- Make sure the external period isn’t set to zero.
- Read temperature value in degrees Celsius with data type “External temperature” (0x0C)
Elektroniksystem i Umeå AB Tvistevägen 48, 907 36, Umeå, Sweden
E-mail: info@elsys.se ǀ Web: www.elsys.se
Specifications in this document are subject to change without notice.
©Elektroniksystem i Umeå AB 2023
Documents / Resources
![]() |
ELSYS ELT2 PT100 Module [pdf] Owner's Manual ELT2, ELT2 PT100 Module, ELT2 Module, PT100 Module, PT100, Module |