ELPRO 645M-4 Cellular and WiFi IIoT Router
Overview
Setting the basic connection and APN
-
- Remove the two screws from the small plate on the back of the modem to access the SIM card holder.
- Slide the silver plate to the left to open the SIM holder.
- Insert the SIM card into the tray, close and lock firmly by sliding back to the right.
- Before switching on the modem, please ensure the antennas are securely connected and connect the 5-40 VDC power supply to the VCC & GND terminals
- Connect the Modems LAN port to a PC via an RJ45 Ethernet cable. Set the PC to obtain an IP address automatically from the modem router. The PC will get an IP address in the range of 192.168.1.XXX.
- Open the Web browser and type in 192.168.1.1 into the Address bar. A Login window will appear, enter the login details as: Username = admin and Password = admin
- From first connection after a factory default (Out of the Box) you will see a Setup Wizard . Fill in the details on each tab and then press the “Finish” button to complete.
- First Tab is the Passwords, Time zone, Modem Name and Language.
- Second Tab is the Mobile connection settings, enter the APN that your provider has said to use with your SIM card, i.e “telstra.extranet, “m2mone.com.au”, etc.
- Third Tab is the LAN IP address you wish to use.
- Forth Tab is WiFi, if it is not used then deselect otherwise fill out the appropriate settings and then press “Finish”
- When all Settings are configured navigate back to: Status > Overview page and the Cellular Status should show “Up”
Dimensions
NOTES
- ALL connections must be SELV (Safety Extra Low Voltage <50V AC & <120V DC)
- WARNING – Explosion Hazard – Do not Disconnect equipment while the circuit is live or unless the area is known to be free of ignitable concentrations.
- “GND” terminal must be connected to EARTH / GROUND as close as practical to the unit.
- To comply with FCC RF Exposure requirements in section 1.1310 of the FCC Rules, antennas used with this device must be installed to provide a separation distance of at least 45 cm (17 inches) from all persons.
Frequently Asked Questions
- Q: What is the default IP address for accessing the router’s configuration?
A: The default IP address is 192.168.1.1 - Q: How do I reset the router to its factory default settings?
A: Press the reset button for 3 seconds to restore the router to factory default settings. - Q: Can I use the LAN port as a secondary LAN connection?
A: Yes, the LAN port can be used as a secondary LAN connection if needed.
Documents / Resources
 |
ELPRO 645M-4 Cellular and WiFi IIoT Router [pdf] Installation Guide 645M-4, 645M-4 Cellular and WiFi IIoT Router, 645M-4, Cellular and WiFi IIoT Router, WiFi IIoT Router, Router |