ELEMENTAL MACHINES ED1 Element D
Applicable Asset Models
- AMI 201RS
- AMI 201RSP
Package Contents
- Element-D
- Power Supply
- Mounting Plate
- Connection Cable
Note: You may receive multiple types of cables if you are connecting Element-D’s to different types of assets.
Safety Information
Review and abide by the safety information found in the Element-D and AMI user manuals. Ensure compliance with your company’s safety best practices, which may include de-energizing equipment before working with electrical connections. Tidy connection cable to prevent tripping hazards.
Installation Instructions
Receiving the Shipment
- If this is your first time setting up the Elemental Machines system, you will receive an email for your dashboardaccount verification. Save this email for when the devices arrive.
- When devices arrive, carefully remove the contents from the packaging. If any of the contents look damaged, please send a picture to help@elementalmachines.com.
- Confirm the Element-Ds in your package are labeled with the assets to which they are to connect. If the labels do not match the intended assets for connection, please contact help@elementalmachines.com.
Element-D Initial Power-up - Move the Element-D for the asset into a dashboard group on the Elemental Insights™ Dashboard. The device status on the dashboard will be listed as ‘disconnected’.
- Plug the Element-D in using the provided power supply.
- Complete the Wi-Fi Connection following instructions in the provided 771-00010 Wi-Fi Connection Guide – Gateway GW2/3, Element-C/D. 771-00010 is included with your Element-D as a printed copy.
- Digital versions of this are available on the Support section of the Elemental Insights™ Dashboard. Attaching Connection Cable to Asset
- Locate the RS-485 terminal block, as shown in Figure 1 on the back of the AMI Oxygen Analyzer.
- Slightly loosen the screws for the three slots of the terminal block. Connect the connection cable as shown in Figure 2:
- Insert the ORANGE WIRE into the slot labeled A. Tighten the screw for the slot to secure the wire.
- Insert the YELLOW WIRE into the slot labeled B. Tighten the screw for the slot to secure the wire.
- Insert the BLACK W IRE into the ground slot (the rightmost slot of the terminal block). Tighten the screw for the slot to secure the wire.
Attaching the Connection Cable to the Element
- Insert the ORANGE WIRE into the slot labeled A. Tighten the screw for the slot to secure the wire.
- Plug the USB end of the Connector Cable into any of the four USB ports (circled in Figure 3) on the Element-D. Positioning the Element-D
- Determine where the Element-D should be placed to allow for power access and a tidy connection cable.
- Securely position the Element-D in the chosen location. The Element-D has magnets which make it easily mountable to magnetic surfaces.
Note: If applicable, an adhesive metal mounting plate available from EM may be used.
Finalization - Confirm that the values appear on the Elemental Insights™ Dashboard.
- If the dashboard does not display any value, check the cable connection. Contact help@elementalmachines.com if the problem persists.
- Set up alert rules on the Elemental Insights™ Dashboard for the Element-D. Guidance on how to do so is available in the Support section of the dashboard.
- Contact the third-party vendor for the next steps regarding communication with the external platform (if applicable).
772-00072 rev 01 Element-D, ED1 AMI 201RS and 201RSP
Oxygen Analyzer Installation Guide 3/3
Copyright 2024 Elemental Machines
help@elementalmachines.com
Documents / Resources
 |
ELEMETAL MACHINES ED1 Element D [pdf] Installation Guide ED1, AMI 201RS, AMI 201RSP, ED1 Element D, ED1, Element D |