How to include the ECO-DIM.10 Z-Wave dimmer into the Fibaro network
- Make sure the Philips Homecenter is installed in the right way.
- Make sure that the EcoDim led dimmer is installed as mentioned in the manual of the dimmer (manual can be found inside the box)
- Switch on the dimmer by pressing the knob. (Lights must be on)
- In case the Fibaro app is not installed, please download and install it via the Google Play Store or the Apple App Store.
- Complete the steps to create a Fibaro account. If there is an existing account you can skip to step 6.
- Start the Fibaro app and click on the “settings” button below.
- Select “Add device”.
- Select “Add device”
- Make sure the pairing mode of the ECO-DIM.10 is activated. If this is not activated you can activate it by pressing the reset button twice. The led indicator will start blinking blue
- The app will indicate: “Inclusion process complete. This device had been correctly added”.
Select: “Next”.
- It is now possible to rename the dimmer. For example, we named the dimmer “SMART dimmer”. After renaming the dimmer, please select: “Next”.
- Now select the room you want to add the device to. When you don’t have created a room yet please select: “Add room” to create a room. Select: “Next” after you created the room. For example, we add the dimmer to the room: “ECODIM TEST”.
- The device is added successfully! The ECO-DIM.10 Z-Wave dimmer is added to the room. Select:
“Finish” to complete the inclusion process. The ECO-DIM.10 Z-Wave device is ready for use.
Documents / Resources
![]() |
EcoDim Z-Wave dimmer in to the Fibaro network [pdf] Instructions Z-Wave dimmer in to the Fibaro network |