Easythreed X3 3D Printer
- This manual is written in accordance with EasyThreed X3 3D printer。
- Printer upgrades and equipment models are slightly different, is a normal phenomenon, based on the actual products received.
- User’s manual inside TF card.
Parts
Parts List: Take out parts from package , check if all parts have as listed below
- Install the XZ Axis set to the Printer Base.
- After insert the XZ Axis, Fixed with 2 screws.
- Connect the Z-axis motor line to the output line of the printer control box as shown in the figure below
- Install the Filament Holder as below.
ShenZhen EasyThreed Technology CO.,LTD
http://www.easythreed.com
info@easythreed.com
Documents / Resources
 |
Easythreed X3 3D Printer [pdf] Instruction Manual X3 3D Printer |
