EAGLETOP 6 In 1 Keyless Entry Lock Instruction Manual

Front/Rear Handle Direction Setting

keypad handle setting

• Left Hand Door
  Rotate the front handle 90 to the left.
• Right Hand Door
  Rotate the front handle 90° to the right.
  

Please keep press the Button of the Spindle. Then, insert the spindle into the Knob. (The spindle bump should be aligned with the hole of the knob) Make sure that the Button is locked into the hole of Knob. The connected spindle pushes the knob into the groove so that the knob is flush with the groove.

Please note that, If the Knob do not be fully inserted into the lock, the front handle with spindle would not be able to rotate normally.

Interior assembly handle setting

Left Hand Door

Right Hand Door

1. Remove the mounting 1 plate.
   
2. Unscrew the rear handle screw.
   
3. Remove the rear handle.
   
4. Rotate the rear handle 90° to the right.
   
   Rotate the rear handle 90° to the left.
   
5. Install the rear handle as shown
   
   Install the rear handle as shown.
   
6. Fix the rear handle with screws.
   
   Fix the rear handle with screws.
   

If you set the front handle at the wrong direction, please follow the instruction below, before installation.

1. Pull out the Spindle and Knob.
   
2. Turn the handle to the correct position
   
3. Insert the Spindle and Knob into front handle.
   

Please note that, If the Knob do not be fully inserted into the lock, the front handle with spindle would not be able to rotate normally.

Documents / Resources

EAGLETOP 6 In 1 Keyless Entry Lock [pdf] Instruction Manual 6 In 1 Keyless Entry Lock, Keyless Entry Lock, Entry Lock, Lock

References

• User Manual