Dsucot DT18_C05 Contact Cable for Cobalt X Data Logger
Introduction
The Dsucot DT18_C05 Contact Cable is designed to interface with Cobalt X data loggers from Techno-Sciences/Emerson. It facilitates direct physical data communication, charging (where applicable), and firmware updates. Commonly used in cold chain monitoring and environmental data logging, this cable ensures a seamless and reliable connection between the logger and a PC or docking station.
Specification
| Feature | Details |
|---|---|
| Model | DT18_C05 |
| Compatibility | Cobalt X Data Logger series |
| Connector Type | Proprietary contact pad (logger side), USB (PC side) |
| Length | 0.5 meters (approx. 50 cm) |
| Cable Material | Durable, shielded plastic/rubber jacket |
| Functionality | Data transfer, device communication |
| Use Case | Environmental monitoring, pharma cold chain, warehousing |
Overview
Dry contact cable to monitor equipment providing dry contact output (door opening-closing, uninterruptible power supplies, air conditioning units, ultra-low-temperature freezers). Connects to a Cobalt X 2.5 mm jack input.
- Open/close (on/off) detection
- For Cobalt X
Installation
- Unpack the Cable
Ensure the DT18_C05 cable is free from physical damage. - Connect to Cobalt X Logger
Align the contact pad end of the cable to the contact port on the Cobalt X Data Logger. It typically magnetically or physically locks into place. - Connect to PC
- Plug the USB end into your computer’s USB port.
- Launch Software
- Open the CobaltView or Emerson Cold Chain software (depending on your model/firmware).
- The logger should be automatically detected.
- Perform Actions
- Download data logs
- Configure logging intervals
- Update firmware (if required)
- Export reports or archive data
FAQs
Q1. Is the DT18_C05 cable compatible with older Cobalt models?
A: No, it is specifically designed for the Cobalt X series. Older Cobalt models may use a different interface.
Q2. What software do I need to use with this cable?
A: Use CobaltView or the Emerson Cold Chain platform, depending on your logger firmware version.
Q3. Can I use this cable for charging the Cobalt X logger?
A: Most Cobalt X models are not rechargeable. The cable is used for data transfer and configuration on
Documents / Resources
 |
Dsucot DT18_C05 Contact Cable for Cobalt X Data Logger [pdf] Installation Guide DT18_C05 Contact Cable for Cobalt X Data Logger, DT18_C05, Contact Cable for Cobalt X Data Logger, for Cobalt X Data Logger, X Data Logger, Data Logger |