DREO DR-HSH004B Atom One With Motion Sensor
IMPORTANT SAFETY INSTRUCTIONS
When using electrical appliances, basic precautions should always be followed to reduce the risk of fire, electric shock, and injury to persons and hyperthermia, including the following:
Do not cover the air inlet and outlet while in operation.
Do not use the fan heater near flammables and combustibles.
GENERAL SAFETY
- Read all instructions before using this heater.
- This heater is hot when in use. To avoid burns, do not let bare skin touch hot surfaces.
- Use the handle to move this heater.
- Extreme caution is necessary when any heater is used by or near children or invalids and whenever the heater is left operating and unattended.
- Do not insert or allow foreign objects to enter any ventilation or exhaust opening as this may cause an electric shock or fire, or damage the heater.
- The output of this heater may vary and its temperature may become hot enough to burn exposed skin. Use of this heater is not recommended for persons with a high sensitivity to heat or an inability to react to avoid burns.
- Do not attempt to modify or repair the product by yourself. Doing so could void the warranty and cause damage or personal injury. Only a repair technician may disassemble or repair this product.
- Make sure that no pieces of polystyrene or other packaging material have been left between elements of the appliance. It may be necessary to pass over the appliance with a vacuum cleaner.
- If the machine is not working as it should, has received a sharp blow, has been dropped, damaged, left outdoors, or dropped into water, do not use and contact Customer Support.
- There may be a trace of smoke or odor when the unit is first operated. This indicates that a drop of oil fell on the heating coil during the manufacturing process. It will quickly evaporate and should not re-occur.
LOCATION SAFETY
- Do not use outdoors.
- Ensure the heater is on a stable, secure surface to eliminate the potential of tipping it over.
- Keep combustible materials, such as furniture, pillows, bedding, papers, clothes, and curtains at least 3 feet (0.9 m) from the front of the heater and keep them away from the sides and rear.
- A heater has hot and arcing or sparking parts inside. Do not use it in areas where gasoline, paint, or flammable liquids are used or stored.
- To prevent a possible fire, do not block air intakes or exhaust in any manner. Do not use on soft surfaces, like a bed, where openings may become blocked.
- This heater is not intended for use in bathrooms, laundry areas and similar indoor locations. Never locate heater where it may fall into a bathtub or other water container.
ELECTRICITY SAFETY
- Always unplug heater when not in use.
- Do not operate any heater with a damaged cord or plug or after the heater malfunctions, has been dropped or damaged in any manner. Discard heater, or return to authorized service facility for examination and/or repair.
- Do not run cord under carpeting. Do not cover cord with throw rugs, runners, or similar coverings. Do not route cord under furniture or appliances. Arrange cord away from traffic area and where it will not be tripped over.
- To disconnect heater, turn controls to off, then remove plug from outlet.
- Always plug heaters directly into a wall outlet/receptacle.
- Never use with an extension cord or relocatable power tap (outlet/power strip).
- If there is a loose fit between the plug and the socket or the plug becomes very hot, the socket may need to be replaced. Check with a qualified electrician to replace the socket.
- It is normal for the plug and cord to feel warm to the touch.
- A plug or cord which becomes hot to the touch or becomes distorted in shape may be a result of a worn electrical outlet. Worn outlets or receptacles should be replaced prior to further use of the heater. Plugging the heater into a worn outlet/ receptacle may result in overheating of the power cord or fire.
- This appliance has a polarized plug (one prong is wider than the other). To reduce the risk of electric shock, this plug is intended to fit in a polarized outlet only one way. If the plug does not fit fully in the outlet, reverse the plug. If it still does not fit, contact a qualified electrician. Do not attempt to rig this safety feature.
- Hyperthermia can result in death. Symptoms of hyperthermia include high body temperature, headache, nausea, vomiting, tiredness, dizziness, fainting, and rapid pulse. If you begin to experience symptoms related to hyperthermia, turn off the heater and seek medical attention.
- To avoid excessive room temperatures which can cause hyperthermia: DO NOT leave product running unattended in a confined space around infants, or individuals with reduced physical, sensory, or mental capabilities.
- Use this heater only as described in this manual. Any other use not recommended by the manufacturer may cause fire, electric shock, or injury to persons.
- CAUTION – High temperature, keep electrical cords, drapery, and other furnishings at least 3 feet (0.9 m) from the front of the heater and away from the side and rear.
WARNING – Risk of Hyperthermia.
WARNING – Risk of Heat Stroke (Hyperthermia)
Hyperthermia can result in death in infants or others
Use caution to avoid overheating Individuals Read and follow all Instructions before use
DANGER – High temperatures may be generated under certain abnormal conditions. Do not partially or fully cover or obstruct the front of this heater.
FOR HOUSEHOLD USE ONLY
READ AND SAVE
THESE INSTRUCTIONS
Gentle Reminder
Specifications
- Model DR-HSH004B
- Rated Power 1500W
- Input 120V-60Hz
- Remote Control CR2025, 3V Battery
HOT SURFACE
THE FRONT SURFACE CAN BE VERY HOT DURING USE.
DO NOT TOUCH WHEN IN USE.
KNOWING YOUR HEATER
Package Contents
USING YOUR HEATER
Control Panel
LED Display
More Features
Memory Function
The heater will remember its last settings (temperatures, working modes, oscillation status) once turned on again.
24-Hour Auto Off
This feature is not ON by default.
When this feature is ON, the heater will shut off automatically after continuously running for 24 hours.
Long press the Timer button for 3 seconds to turn this feature ON/OFF when this heater is on standby. The display will show” or:” and “OF” respectively.
Tip-Over Protection
When the heater is tipped over, it will shut off automatically with the error code “P4” on the display.
Overheat Protection
When the heater overheats, it will shut off automatically with the error code “FF” on the display.
Remote Control
Battery Replacement
- Keep the locking tab pressed while pulling out the battery holder from the slot at the back.
- Replace with the same battery type with the(+) side facing up.
- Push in the holder until securely locked in place.
Note: If the appliance doesn’t respond when using the remote control in close range please consider replacing the battery.
WARNING
- INGESTION HAZARD: This product contains a button cell or coin battery
- DEATH or serious injury can occur if ingested.
- A swallowed button cell or coin battery can cause Internal Chemical Burns in as little as 2 hours.
- KEEP new and used batteries OUT OF REACH of CHILDREN
- Seek immediate medical attention if a battery is suspected to be swallowed or inserted inside any part of the body.
- Remove and immediately recycle or dispose of used batteries according to local regulations and keep away from children. Do NOT dispose of batteries in household trash or incinerate.
- Even used batteries may cause severe injury or death.
- Call a local poison control center for treatment information.
- Compatible battery type: CR2025.
- Battery nominal voltage:3.0 Vdc
- Non-rechargeable batteries are not to be recharged.
- Do not force discharge, recharge, disassemble, heat above (rated temperature: 140 °F) or incinerate. Doing so may result in injury due to venting, leakage or explosion resulting in chemical burns.
- Ensure the batteries are installed correctly according to polarity(+ and -).
- Do not mix old and new batteries, different brands or types of batteries, such as alkaline, carbon-zinc, or rechargeable batteries.
- Remove and immediately recycle or dispose of batteries from equipment not used for an extended period of time according to local regulations.
- Always completely secure the battery compartment. If the battery compartment does not close securely, stop using the product, remove the batteries, and keep them away from children.
CLEANING AND MAINTENANCE
TROUBLESHOOTING
If your problem Is not or still persists, contact our Customer Support (see page 17).
OREO CUSTOMER CARE
Default 12-Month Warranty
This appliance is covered by Oreo warranty for 12 months from the date of its original purchase.
Extend Your Warranty
Extend your warranty by registering your new appliance on our website https://dreo.com/warranty
The warranty will not apply in cases of:
- Accident, misuse, or repairs performed by unauthorized personnel.
- Any unit that has been tampered with or used for commercial purposes.
- Normal wear and tear of wearable parts.
- Use of force, damage caused by external influences.
- Damage caused by non-observance of the User Manual, e.g. connection to an unsuitable mains supply or noncompliance with the instructions.
- Partially or completely dismantled appliances.
- Defects caused by or resulting from damages from shipping or from repairs, service, or alteration to the product or any of its parts that have been performed by a repair person not authorized by Oreo.
We can only provide after-sales service for products that are sold by Oreo or Oreo-authorized retailers and distributors. If you have purchased the appliance from a different place, please contact your seller for return and warranty issues.
FCC Statement
This device complies with Part 15 of the FCC Rules.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.
Please note that changes or modifications of this product is not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and the receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference, and
- This device must accept any interference received, including interference that may cause undesired operation.
We’re Here to Help!
888-290-1688 Mon – Fri. 9:00 am-5:00 pm PST/PDT
support@dreo.com
Shenzhen Hesung Innovation Technology Co., LTD us
26F, Bldg A7, Creative City, Shenzhen, China
Documents / Resources
![]() |
DREO DR-HSH004B Atom One With Motion Sensor [pdf] User Manual DR-HSH004B, DR-HSH004B, DR-HSH004B Atom One With Motion Sensor, DR-HSH004B, Atom One With Motion Sensor, One With Motion Sensor, Motion Sensor, Sensor |