REVERSE EDGE / RED GREEN
LED INSTALLATION
DoorKing Part Numbers
8080-080
Reverse Edge
8080-096
Reverse Edge+ Red/Green LED

Reverse Edge Barrier Gate

This kit is designed to install on a 14 ft aluminum octagon arm for a 1601 barrier gate operator or a 1603 auto spikes operator.
It CANNOT be used with a 1602 operator.
Note: DO NOT operate arm with a malfunctioning reverse edge.

Installation

1. Remove End Cap
   Push a screwdriver through hole in bottom of end cap to release spring while pulling cap off.
2. Slide on Stopper
3. Slide on Edge
   Tip: Liquid soap will help reverse edge slide on easier.
4. Reinstall End Cap
   Push a screwdriver through the hole in cap to release spring while pushing cap on. Keep pushing cap on until a “CLICK” is heard which locks it in place.

Documents / Resources

DKS DOORKING Reverse Edge Barrier Gate [pdf] Installation Guide Reverse Edge Barrier Gate, Edge Barrier Gate, Barrier Gate, Gate

References

• User Manual