dji MT2PD2007 Camera Drone User Guide

dji MT2PD2007 Camera Drone

Aircraft

DJIMini 2 features Obstacle  Sensing and Infrared Sensing System, and a fully stabilized  3‐axis  gimbal with a 1/2.3” CMOS sensor camera that shoots 4K video and 12-megapixel photos.

1.  Gimbal and Camera
2.  Power Button
3.  Battery Level LEDs
4.  Downward Vision System
5.  Infrared Sensing System
6.  Motors
7.  Propellers
8.  Antennas
9.  Battery Cover
10.  Charging/Upgrading Port (USB‐C)
11.  microSD Card Slot
12.  Aircraft Status Indicator

Remote Controller

Built into the remote controller is  DJI’s long‐range transmission technology  OCUSYNCTM  2.0,  offering a maximum transmission range of 5 mi (8 km) and displaying video from the aircraft to DJI Fly on your mobile device at up to 1080p.

1.  Power Button
2.  Flight Mode Switch
3.  Flight Pause/RTH Button
4.  Battery Level LEDs
5.  Control Sticks
6.  Customizable Button
7.  Photo/Video Toggle
8.  Remote Controller Cable
9.  Mobile Device Holder
10. USB‐C Port
11.  Control Sticks Storage Slot
12.  Gimbal Dial
13.  Shoot/Record Button

Download the DJI Fly App and Watching Tutorial Videos
Search “DJI Fly” in the App Store or Google Play or scan the QR code below to download the app on your mobile device.

Charging the Batteries

Checking the Battery Levels and Powering On/Off

• Press once to check the battery level.
• Press, then press and hold to turn on/off.

Preparing the Aircraft

1.  Remove the gimbal cover from the camera.
2.  Unfold the front arms and the propellers.
3.  Unfold the rear arms and the propellers.
4.  Unfolded

NOTE:
Unfold the front arms and the propellers before the rear ones.  All arms and propellers must be unfolded before takeoff.

Preparing the Remote Controller

1.  Attach the control sticks.
2.  Pull out the mobile device holder, and then unplug the end with mobile phone mark of the RC cable.
3. Place the mobile device onto the mobile device holder, and plug the RC cable into the mobile device.

NOTE:

•  Ensure the control sticks are firmly mounted.
•  The remote controller cable with the  Lightning connector is mounted by default. Use the appropriate cable for your mobile device to connect to the remote controller.

Preparing for Takeoff

1.  Power on the remote controller
2.  Power on the aircraft
3.  LaunchDJI Fly App

Flight

Remote Controller Operation

Specifications

• Aircraft (Model:MT2PD)
  

  Weight	241 g
  Max Flight Time	30 minutes (0 wind while flying at a consistent 15.5 mph (25 kph))
  Operating Temperature	32° to 104°F (0° to 40°C)

• Camera
  

  Sensor	1/2.3’’ CMOS; Effective pixels: 12M
  Lens	FOV: 83° 35mm format equivalent: 24 mm Aperture: f/2.8 Focus: 1 m to ∞
  ISO Range	100‐3200
  Electronic Shutter Speed	4‐1/8000 s

• Remote Controller
  

  Operating Voltage

  1200mA @ 3.7V (Android) 700mA @ 3.7V (iOS)

• Intelligent Flight Battery
  

  Capacity	2250 mAh
  Battery Type	LiPo 2S
  Charging Temperature	41° to 113°F (5° to 45°C)
  Max Charging Power	29 W