![]()
DIO LED123LL LED Light Bar with Sensor Switch Instruction Manual
LED123LL
LED light-bar with sensor switch
Specifications
Installation
3 way mount
Short press – On/Off
Safety and disposal instructions
- LED-luminaires should only be replaced if the power has been disconnected.
- Do not use damaged luminaires.
- LED-luminaires should only be installed and used according to the manufacturer‘s instructions. Permissible voltage and power rating of the lamp must be observed without fail. Values below or above the limit can damage the LED-luminaires.
- Operation with starter lamps in the same circuit is not permitted.
- The lamp should be cleaned regularly for a long lifetime.
- The installation may only be carried out by a qualified electrician.
- No disposal of defective luminaires with household waste.
- Return via public collection points.
David Communication e.K. . Gewerbestraße 10 . 21391 Reppenstedt
Documents / Resources
 |
DIO LED123LL LED Light Bar with Sensor Switch [pdf] Instruction Manual LED123LL, LED123LL LED Light Bar with Sensor Switch, LED Light Bar with Sensor Switch, Light Bar with Sensor Switch, Sensor Switch |