digitech YN-8074 Network Switch
Box Contents
- 1 x 5 Port PoE Switch
- 1 x Wall Mounting Bracket & Hard
- 1 x Power Supply
- 1 x Power Supply Lead
Product Diagram
| LED Status Indicator | Status | Description |
| Link | On | Network Connection Working |
| Flashing | Receiving / Sending Data | |
| PoE / Power | On | PoE / Power Output Working |
| Flashing | PoE Output Interruption | |
| Off | No PoE / Power Output |
Connection Diagram
Operation
- Connect the power supply lead in to the socket on the mains power supply.
- Connect the mains power supply to a 240VAC power outlet.
- Plug in the DC plug of the mains power supply in to the DC socket located on the rear of the PoE switch.
- The green power LED status indicator should now be lit indicating that the unit is now on.
- Connect your required PoE devices using Ethernet cables (not included) to the PoE ports located on the switch.
Note: It is strongly recommended that the earth (ground) be connected.
Safety Instructions
- Ensure the vents on the sides of the units are not covered.
- Ensure that the earth (ground) is connected to avoid electrical shock
- Do not position the unit close to any heating source or in direct sunlight.
- Ensure the unit does not come in to contact with any water or moisture as it may damage the unit.
Troubleshooting
| Problem | Solution |
| Power LED Not Turning On | Check if the mains power supply is properly connected to a 240VAC Outlet |
| Check if the DC plug of the mains power supply is connected properly to the socket of the switch | |
| Check if the LED power supply is working, the LED on the power supply should be lit up | |
| Link LED Not Turning On | Ensure the device you have connected is switched on |
| Check that the ethernet cable is connected properly on both the device and the switch |
Specifications
Ports: 4 x PoE (RJ45) 1 x Uplink (RJ45)
Power Output: 30W Per Port (Max) 15.4W Per Port (Across 4 Ports) 65W (Total)
PoE Standards: IEEE 802.3at (DTE Power Via MDI), IEEE 802.3af, IEEE 802.3x (Flow Control), IEEE 802.3u (100 Base Tx), IEEE 802.3i (10 Base T)
Network Speed: 10/1 00Mbps
Bandwidth: 1.6Gbps
Buffer Memory: 96Kb
Transmission Speed: Up to 1 00m
Pin Assignment: Data (1 /2 & 3/6), Power (1 /2+ & 3/6-)
Network Ports: Auto Negotiation, Auto MID, Auto MDIX
Power Supply: 52VDC, 1.25A
Dimensions: 118(W) x 85(D) x 27(H)mm
Customer Support
Distributed by:
TechBrands by Electus Distribution Pty. Ltd.
320Victoria Rd, Rydalmere
NSW 2116 Australia
Ph: 1300 738 555
lnt’I: +61 2 8832 3200
Fax: 1300 738 500
www.techbrands.com
Documents / Resources
 | YN-8074 Network Switch |
References
- Manual-Hub.com - Free English product PDF Documents!manual-hub.com
- User Manualmanual.tools
Published: February 9, 2024
Updated: February 10, 2024