User Manual
Slim line LCD Clock With Thermometer
XC-0230
Distributed by:
TechBrands by Electus Distribution Pty. Ltd.
320 Victoria Rd, Rydalmere
NSW 2116 Australia
Ph: 1300 738 555
Int’l: +61 2 8832 3200
Fax: 1300 738 500
www.techbrands.com
Specifications:
| Time Display: | 12/24 hour selectable |
| Temperature Display: | °C/°F selectable |
| Digit height: | 35mm |
| Temperature Range: | 0°C-50°C (calibration time: 30 seconds) |
| Power: | 2 x AAA batteries (not included) |
| Dimensions: | 215(L) x 73(H) x 22(D) mm |
Instructions:
– Open the battery compartment and insert 2 x AAA batteries in the correct polarity.
– Press and hold down the ‘SET’ button for 2 seconds, the hour display will start to flash.
– Use the ‘▲’ and ‘▼’ buttons to set the correct hour, press ‘SET’ to confirm the setting.
– The minute display will start to flash, use the ‘▲’ and ‘▼’ buttons to set the correct minute and press ‘SET’ to confirm the setting.
– The setting up procedure is now complete and the clock is ready for use.
– To change between 12/24 time format, press the ‘▲’ button to switch between the modes. In 12-hour format, the AM and PM symbols will appear on the display with the time.
– To change the temperature between Celsius and Fahrenheit, press the ‘▼’ button to switch between the modes.
NOTE:
– When the LCD display becomes dimmer, please replace the batteries.
– Only use AAA batteries in this timer.
– Ensure not to mix old and new batteries.
– Please dispose of used batteries in a responsible manner.
– Never attempt to open, modify or repair the clock in any way.
– Never get the clock wet.
Documents / Resources
 |
DIGITECH XC-0230 Slimline LCD Clock With Thermometer [pdf] User Manual XC-0230 Slimline LCD Clock With Thermometer, XC-0230, Slimline LCD Clock With Thermometer, LCD Clock With Thermometer, Clock With Thermometer, Thermometer |
