DigiMax HMP-38HS 3 Head Mounting Plate with Hex Stud Instructions
Mounting a Head
- Screw the tripod head onto the 3/8-16 thread. Make sure the head is flush against the mounting plate.
- Tighten the setscrews with a slotted screwdriver until the head is secure. Don’t overtighten.
- Loosen the receiver’s or super clamp’s locking knob, press and hold silver safety button. Then fully insert the hex stud into the receiver, release the safety button, and tighten the locking knob.
Impact HMP-38HS 3/8-16 Head Mounting Plate with Hex Stud
Read More About This Manual & Download PDF:
Documents / Resources
 |
DigiMax HMP-38HS 3 Head Mounting Plate with Hex Stud [pdf] Instructions HMP-38HS 3 Head Mounting Plate with Hex Stud, HMP-38HS 3, Head Mounting Plate with Hex Stud, Mounting Plate with Hex Stud, Plate with Hex Stud, Hex Stud |
