DIGILOG ELECTRONICS SY1024H
24v 10a Solar Charge Controller
User Manual

SAFETY INSTRUCTIONS

1. Make sure your battery has enough voltage for the controller to recognize the battery type before first installation.
2. The battery cable should be as short as possible to minimize loss.
3. The regulator is only suitable for lead acid batteries: OPEN,AGM, GEL it is not suited for nickel metal hydride, lithium ions or other batteries.
4. The charge regulator is only suitable for regulating solar modules.

Never connect another charging source to the charge regulator.

PRODUCT FEATURES

1. Build-in industrial micro controller.
2. Big LCD display, all adjustable parameter.
3. Fully 4-stage PWM charge management.
4. Build-in short-circuit protection, open-circuit protection, reverse protection, over-load protection.
5. Dual mosfet Reverse current protection ,low heat production

LCD DISPLAY/KEY

SYSTEM CONNECTION

1. Connect the battery to the charge regulator – plus and minus.
2. Connect the photovoltaic module to the regulator – plus and minus.
3. Connect the consumer to the charge regulator – plus and minus.
   The reverse order applies when deinstalling!
   An improper sequence order can damage the controller!

DISPLAY/SEETING

Attn:

1. press the [Down] button to ON / OFF load manually at main display.
2. the work mode is working as below:
   [24H]  –  load output 24 hours
   [1-23H]   –  load on after sunset and closed after setting hours
   [0H]  –  Dusk to dawn

Troubleshooting

Technical Parameter

*all red color voltage X2 ,X4 while using 24V /48V system.
*Product specifications are subject to change without prior notice.

Documents / Resources

DIGILOG ELECTRONICS SY1024H 24v 10a Solar Charge Controller [pdf] User Manual SY1024H, SY1024H 24v 10a Solar Charge Controller, 24v 10a Solar Charge Controller, Solar Charge Controller, Charge Controller, Controller

References

• User Manual