DigiKuber TK70 Smart Watch
Specifications
- Model: %B’JU
- FCC Compliance: Part 15 of FCC Rules
- RF Exposure: General RF exposure requirement met
- Usage: Portable exposure condition without restriction
Product Usage Instructions
- Ensure the device is charged before initial use.
- Power on the device by pressing the designated button.
- Follow the user manual for specific functions and settings.
- Avoid exposing the device to extreme temperatures or moisture.
- If experiencing any issues, refer to the troubleshooting section in the manual.
Watch charging and activation
For the first time using, please align the watch with the adsorption charging cable to charge and turn it on. The USB end of the charging cable needs to be connected to a 5V 1A power supply. The charging indicator will appear on the watch screen. When the watch indicates low battery, please charge it in a timely manner. This device belongs to an all-in-one device, and the rear case and battery cannot be disassembled.
Mobile client download
Scan the QR code below to download and install the mobile client
Bluetooth one-click connection method
one. After installing the app, open Da Fit and turn on Bluetooth on your phone. There will be an activation notification prompt; click Allow. two. Click on the device icon at the bottom of the APP interface to enter the Add Device page. Click on the plus sign to add a device, search for the corresponding Bluetooth name of the product, and click Connect. All the “Pairing” and “Allow” pop-up messages on the phone will indicate a successful connection. three, some Android phones require the phone ors to be turned on in order to find the Bluetooth name of the watch
FAQ
The watch cannot be turned on
Please hold down the power button for more than 3 seconds or the battery may be low. Please charge it promotly
Bluetooth not connected or unable to connect
one. Please try restaning ine Watch and reconnectino two. Please try restarting your phones bluetooth and connecting three. Do not connect your onone to otel bluetooth devices at the same time
Inaccurate measurement of heart rate, blood oxygen, etc
one. It is generally caused by poor contact between the sensor of the watch and the human body during measurement two, Please pay attention to tull contact between the sensor and the wrist during measurement
Insufficient accuracy of sleep data
one. Sleep monitoring simulates a person's natural state of falling asleep and waking up, and requires normal wearing two. Wearing it too late or when sleeping may cause errors three, During the day, sleep data is not monitored. The default sleep monitoring is from 20:00 pm to 11:00 pm the next day, and sleep occurs, Time: 20:00 to 04:00 the next day The watch functions will be updated from time to time, and please refer to the actual product for accuracy
Documents / Resources
 |
DigiKuber TK70 Smart Watch [pdf] User Manual 2BLM5-TK70, 2BLM5TK70, tk70, TK70 Smart Watch, TK70, Smart Watch, Watch |