DieseRC 2201COM Wireless Remote Control Switch

Technical Data
| Working Voltage | AC 85V-250V / DC 7V-32V / 5V |
|---|---|
| Trigger/Output Voltage | Passive Output |
| Output Type | Relay |
| Output Current | 5A |
| Amount of Remote Control | 50 pcs |
| Amount of Working Mode | 4 |
| Remote Control Distance | 50m |
| Working Temperature | -20°C to 60°C |
| Receiving Sensitivity | -105dBm |
| Remote Control Frequency | 433.92MHz |
| Remote Control Type | Learning Code |
| Remote Control Mode | Momentary/Toggle/Latched/Delay Mode |
| Voltage | AC 85V-250V / DC 7V-32V / 5V |
|---|---|
| Current | 5A |
| Frequency | 433.92MHz |
| Temperature | -20°C to 60°C |
Wiring Diagram
The wiring diagram shows connections for AC devices and manual switches. The receiver is connected to an antenna for signal reception.
Product Details
- Antenna
- Indicator Light: CE, FC
- Learning Button
- USB 5V Input
- Relay Output: NO (Normally Open), COM (Common Pin), NC (Normally Closed)
Installation Instructions
- Press the learning button three times on the receiver.
- Wait for 3 seconds.
- Press a button on the remote control.
- Successful pairing will be indicated.
Operating Modes
- Momentary Mode
- Press and hold a button, the relay will turn on.
- Release the button, the relay will turn off.
- Toggle Mode
- Press the “A” button, the relay will turn on.
- Press the “A” button again, the relay will turn off.
- Latched Mode
- Press the “A” button, the relay turns on.
- Press the “B” button, the relay turns off.
- Delay Mode
- Press the “A” button, the relay turns on.
- Release the button, the relay will configure after 5 seconds.
- Reset Instructions
- Press the learning button on the receiver 10 times.
- Wait for 3 seconds.
- Press a button on the remote control to reset.
Documents / Resources
![]() | 2201RCOM Wireless Remote Control Switch |
References
- User Manualmanual.tools
Published: June 7, 2026
Updated: June 8, 2026

